The spade by the empty beside the blue wire on back of panel is that where the ground wire comes out? Trying to figure out where the ground wire hooks into the back of your panel I hv same panel Seems to me I need to pull all the blue wires o. Switch panel but your lights were working. Think I’m over thinking this. Running my nav lights and stern light together as one thanks
Hopefully you will get this question and I’ll lv you alone. Question: What did you do with that one red wire that’s cut sticking out in video on the right hand side of switch panel? Isn’t that wire hot? Did you just tape it off?thanks
That red wire went to a separate switch so that I can cut off the battery voltage and usb ports. Otherwise it would draw power constantly. So if I want to check my voltage I flip a separate switch to power that top row
Dought you read these posts anymore but I hv a panel nearly like yours but my 3 accy on top( igarette lighter plug, volt meter digital, USB port) I cut the in line fuses out soldered usb/ Cig lighter plug together and I. Wire coming out, it will wire into my fuse panel u dr accy, now I o my hv black wire goes to positive power on fuse panel, soldered blue/yellow wire together 1 wire going to beg side of fuse panel. I have it done correctly right or seems right to me, I can’t see any other way but I do make mistakes. But I can’t send a pic of the wiring and labeling of wires where they go, can’t attach much less can’t come tact you personally thanks Steve
Ok so your going in from fuse panel to top spade of switch, going out on bottom spade in panel, ground wire coming from light goes to negative side of fuse panel. Got cha.