How to install a plastic guttering system - OSMA Rainwater 

Did mine on a 12 ft timber shed. I put a water butt under the downpipe for collecting rainwater. The string tip is a great idea (make sure the your baseboard is level) Works a treat. Well designed products.

Finally! a video that tells me whether I need to leave an expansion gap on the stop end that goes up against the wall. 👍

Thank you, very helpful video and nice clean tidy job.

Helpful video, thanks a lot

Really well explained, thanks

Good video, Thanks.

Thanks for sharing your ideas

Spot on mate!!

Great vid 👍

That was very interesting and helpful, thank you very much..

The result of stringlining into the outlet is that the line rests on the rubber seal which, upon installation, is compressed and this results in an increased fall between the final bracket and the outlet. I note you make this symmetrical by having an approximately 1mm fall (in 200mm ish = 1:200?) on the short section of gutter on the other side of the running outlet. To me the increased fall looks wrong, but I wonder if this is for a technical reason? What I don't understand is why a quality manufacturer such as OSMA forces installers to rely on eyeballing (6:02) the union bracket to ensure correct alinement. It would be great if a manufacturer would consider a way that the position of the union bracket could easily be marked to be precisely in line with the run of the gutter (perhaps the bottom of the union bracket might finish in line with the bottom of the adjacent support brackets?). Perhaps that might be a future project for your R&D department?

How do you fix guttering that has warped or moved out of alignment over time?

Hi, great instrucrion video, thank you. You didn't mention how to secure the downpipe clips i.e. into the brick or into the mortar? And whether you recommend rawlplugs or or going straight in with tapcons or self tappers etc. Please can you advise?

What if the fascia board is not level and youre measuring from the bottom for your fall?

Thank you for this helpful video... I just wondered how you calculate the mathematics for the fall gradient of the guttering. Do you times the length of the gutter by the 1.6 mm rule or is it another equation to reach the total overall fall? I am finding that part of my project rather challenging so any advice would be very much appreciated🤔?

Fill the original holes to prevent water ingression? Birdy

Are ordinary woodscrews able to get a sufficient grip into PVC?

like the looks of this system - doesn't seem to be available in the US, or is it?

How can i by this gutter and how much and from Where

Ye should make it mandatory for installation companies to watch the 1.6 mm per m slope!

Pina-men lol 👷🏻‍♂️🍺

Were is that? The name of the city?

.

It should be 5 brackets on a guttering with it being 600 mm apart each bracket and also 1mm drop every bracket and it should have a fall of 5mm on other end

Why measure on a slack plumbline?

Ducking cowboys