How To Install BT Moto IAT and Flapper Kit For 19+ S1000RR/R/XR, M1000RR 

Why don't u remove flappers and reinstall servo back in ?

do you need a tune after doing this?

oops - your glove rubber ended up in the throttle body...

I’m stuck on the clamp

Based on some logic, my insight about the IAT relocation would be this: we all agree that the air in the airbox is hotter than one in outside the bike. Especially at lower speeds or on traffic. As we relocate the sensor outside the airbox, it will read a lower temperature, but we don’t relocate the engine itself, so engine would still receive the higher temp. air. (Same temperature, as the iat would read in its original location) What we get after this mod is the ECU thinks the air is cooler than it actually is and gives more fuel. The bike starts to run rich, that means a poor air/fuel ratio and lower hp. I cannot understand how do they receive additional power from this mod. Tell me your insights.

I have a 2020 xt I put it way forward its visible from the intake in front and has no conflicts w steering and is completely hidden from view by plastics. Can send you photos if you want since I'm servicing rhw head bearings.

I see how you getting a closeup of them guns 💪 be carful you’ll break the camera😂

So easy nice You want an install Mod for roll racing please I want learn

If you get the Stage 2 tune and opt for the flappers to remain open, then this is no longer necessary, correct?

I just finished doing the flapper delete and ait relocation. I haven’t done the tune yet but now I have an engine control fault but it still runs normal. Is that to be expected?

Is it worth putting the carbon fiber intake?

are you unable to keep the flapper open through software like in previous 2020+ models?

How would you do a gs re learn? My dad has curious fingers on the xr