While it would add to the cost, you can use a PVC pipe fitting for the suction connection. As it turns out, shop vac hoses fit PVC fittings pretty well
... идея отличная получилась и работа проделана огромная!-, для пылесоса осталось сделать или колёсики, или рукоятку для переноски и транспортировки, молодец, здоровья тебе и удачи во всём новых творческих успехов!!!
The wet vacuum demonstration = the moisture/vapour generated by the water being sucked up will damage & eventually kill this particular vacuum motor as it is for filtered dry air only - due to how it is cooled, and as it has “no” indication of when it is full of water = the motor will flood and die if a large amount of water [over the capacity of the lower box] is being vacuumed.
@@bobweiram6321 but, still, if he would have sucked more water at once (submerging the whole hose under the water, creating a huge suction) then it could maybe suck the water in. I create a separate container for the water with a plastic ball on top of the hose to block any suction when the tank fills up. Also thought about the cyclone.
True it's only about as powerful as a low to mid range cordless, now adding another 2/3 of those motors would give this the juice that pipe size deserves lol
It will have less load with less flow. It still needs a little bit of flow but in some cases like air conditioners, having maximum flow can overload the motor but slightly restricted flow is best
At one point i saw the chisel pointed at your hand securing the lid. Never keep your fleshy bits in the path of the chisel. If it slips its going straight into your hand.
This is a really cool build. Would love to see you iterate on it and make a better filtration system for it. A cyclonic system would work well. These pleated filters always clog in shop vacs and reduces the suction a lot.
excellente réalisation , mais il manque une chicane entre l'entrée de l'air et ses saletés et son trajet vers le filtre, avec une chicane le filtre se bouche moins vite
Идея интересная, но есть у меня сильное подозрение, что в такой конструкции двигатель проработает не долго. Перед ним нужен ещё один фильтр, или хотябы мелкая сеточка.
@@108venigm Весь смысл этого пылесоса именно в том, что он без мешка и может собирать воду. Тогда уж проще купить обычный недорогой пылесос и сделать для него нормальный мешок.
Nice build! I like the modularity (assuming that you use Turnover Boxes extensively in your organizational system.) 2 suggestions if your are open to them. 1st when you put the latches on, I like that you install them before apply the sealing strip so that it will seal with the preser from the foam. If you put the latches on the top box or the "body of the vacuum" just like you did with the foam sealing strip then any turnover box of the appropriate size could be used as all necessary parts are on one piece. 2nd I agree with Samuel Fellows the motor electronics are quite vulnerable in this build perhaps an enclosed motor or shaft driven turbine and have the motor out of the air stream. Love the idea.
