How To Make A RJ45 To RJ11 Cable. Ethernet To Phone Cable For Fax Machine Today I Learned With Billy 

Thanks Billy. 2 years later and this is still helping folks

Haven't had to mess with RJ11 in so long but of course had to fix something this morning in a rush. Thanks for the great video!!!

This video saved me hours today! Thank you so much Billy!

thank you. salamat

Thanks👍🏻

Hello my line on the street comes with 2cables i think its rj9? how to i connect the rj45 on it?

Same thing on the other side right? I have cat 5 through a wall and I want to pass the analog phone line through it to another room.

I would still need a DSL Splitter, if I want to receive signal from my rj11 port used for telephone and internet in the past?

Pls is the RJ11 a 6P4C or a 6P6C type?

What make/model of RJ11 connector did you use? CAT5 cable is pretty thick (about 0.2" diameter), and I've tried putting an RJ11 connector on round cable that was only 0.175" thick and the opening in the back was too small to allow the outer insulation to push far enough into it to get a good strain-relief crimp. The connector I used was supposedly for round cable (rather than flat), but it still didn't work well. The outer insulation pulled out of the strain-relief crimp in short order.

can this still work through a phone jack outlet and get ethernet connection into the PC? or do you have another video that deals with that?

can i do the opposite ? i mean rj11 to rj45??

Thanks for the tutorial How to do it for an rj11 with only 2 pins?

But how do you go from phone to ethernet my modem has rj11 jack but I am running a cat6 for phone and ethernet

In your cable, will it be able to use in internet connection?

Omg thank you! Why can't anybody else teach this way? Any pointers for locating an analog phone demarc that has no punchdown block? lol. Two other questions though: 1) being OCDish, is the Ethernet cable jacket fitting properly in the smaller RJ11 connector square hole? (providing strain relief, but not overly crowded). 2) Your heatshrink labels. Do you actually shrink them onsite or do you just keep them able to move along the cable?

how about rj45 to rj11 using cat6 for ip phone..what is the colour code?😅

If the rj11 patch cable can fit in an rj45 jack why does this even need to be done?

I have a regular phone line that has my interest going through it. The colors are red, green, black and white. They are connected to the old style connector that is round and has the 4 screws with the red, green, yellow and black wires attached. From there it goes to the back of the wall plate we’re the Rj45 connects. I want change out the wall plate and have one with the connector plugging right into the back of the wall plate and eliminate the round connector with screws because I have a patch cable going to another room and I need to use this box. I don’t know how to connect the 4 wires. The black, white, green and red to the rj11 so that it will match the cat 5 on the other side of wall plate.

Awesome job. If you had One wish, what would it Be? Let's build each other up xP

Bruh, the cable is not blue with a white stripe it's white with a blue stripe.