Thanks for the tip on the nail gun… I didn’t know orientation of the gun itself would make a difference on blowout. Great tip and an enjoyable video as always. Best to you and yours.
Love your stuff Jon, but one simple and cheap suggestion for these boards that will make them even more useable....four rubber feet. I use 1" rubber feet held in place with a center screw. Nothing is more annoying than chasing a cutting board across a super slick granite counter top, and the rubber feet cure that issue.
Thanks for sharing. I watched this video, went out to my shop and made up the handle jig and It worked fantastic on the big cutting board I have been working on. Also thanks for the tip on cutting the juice grooves. I had already cut my juice grooves on this board, but this system looks a little easier.
Yeah Boyee!! These both came out really cool Jon. I think bloopers would be an extremely enjoyable touch to some of your videos Bud. Hoping all is well, Dirty Jersey out!!
Jon, have a good Thanksgiving! Folks, support this channel because Jon and his wife have to feed their giant sons Thursday. That’s gonna run into the thousands of dollars.
First, Happy Thanksgiving to you and yours Jon!!! I need to head back to New Jersey one day to visit family. Great video. Just took a 3D cutting board class from Alex Snodgrass...still need to finish sand it and may very well take your instruction above into account as I finish it. Thank you!
Haven’t seen a juice groove made that way before, might be my new favorite way! Jon, do you ever raise the grain on your cutting boards before sanding?
wow that's an aggressive finger groove. I've always just use my 1" core box bit on the router table but even then I'm only using half the bit so the groove only goes half an inch in. Perfect for getting your fingers right under there though
Nice work, but I think the finger cutouts are too far in from the edge for aesthetic reasons, they don't need to be more than 2 knuckles deep to be ergonomic. Cheers