How to Operate a Servo in Speed Control 

this drive can receive pwm + dir signal? i want to use it with my arduino

i am looking for technician for maxsine servo drives machine stopped and jog motor not moving properly

Hi, I have 3 servo drives, the motors are DC synchronous with the drives integrated in the housing. I read all the documentation that I could find about this motors, and I still am trying to figure out how i will connect this motors as that it receives the signals from a G-code Software. There is 2 input pins for data and 4 for power and ground. .. 24 volts for the drive, 300 volt dc for the motors and 5 volt for something else.. the data pins are 2 and are named high Can and Low Can. I figured that the signal transposting the data are can protocol, so i am going after some information of this technology and as I could understand so far, Can bus are only the protocol of data transfer from the controling unity to the servos .. What I am trying to figure, without resources to test, is ... what kind of signals should be sent from the controling board via can bus to the drives, and if there is any device that will be needed to translate this signals into can bus before it reachs the drive.. Sorry about my question, it may sound dumb to someone whos expertise is beyiond mine, but i need this information to progress in my project and in my knowledge of this systems.. . Anyone can help? I reformulate the question if it is not well presented.. Thank you

Sarji meri Sarvo mortar ka Lok htana he tariff ka btado net pe

Wiring position control mode servo drive AASD ???

Hi dear According to the attached image, an alarm has been generated in the drive display, how to fix the problem (Alarm display A.04 Overload : The servomotor is operating continuously under a torque largely exceeding ratings) Where is the problem and how to solve this problem? Thank you for your guidanc Best regard

Hi, what is driver conts from 1 to 5 and not start up? Only see 5 number on lcd, thanks

can you tell me how to connect this driver in position control mode and which parameters must be changed please?

Bilkul bakvash sound bilkul bhi nahi hai.

thanks very nice

Sd310का विडियो

Nice

Talkless. workless.