How to rebuild and replace front shocks / struts in Holden VT to VZ commodore - VZ SSZ 

thanks a heap mate great help just trying to help u out with a comment alot of people take help videos for granted but ur doing gods work :) thanks mate

Thanks for the video, doing this job this weekend on my VZ

Very helpful and simple to follow.

Hello any idea from where i can get it for the Holden statesman 2004 wk wl/ chevrolet caprice?

Yea not a bad deal, I did mine on the VY 4 years ago and still firm.

Good video , hope everyone is having a great day😊

Shocking video.. Thanks

check the bolts supplied,nuts had rock in them so i used the new bolts with the old nuts with a dab of locktight and old boot covers as ones supplied did,nt fit,other than that all good.going to contact webco to maybe check things before shipment.

Any idea where i can get my Holden statesman 2004 WK/WL / Chevrolet caprice 2004 suspension?

Awesome. Im going to give this a go shortly on my CV8Z Monaro. The only thing that is different is tab for mounting the sway bar link pin. Its a horizontal assembly as opposed to the vertical one shown here. Its a bit more of a complex design but essentially it does the same thing. See what happens when I get there. :)

After doing my struts which were rooted amd replaced bump stop, bearing , strut top the top plate has a small gap and some movement,

thanks heaps for the video. I've actually bought the same shocks for my VZ Commodore Ute. What's the size of the hex to hold the strut still when turning the main nut off (15/16)? It seems to be 13/32 from what I can tell and I can't get hold of one anywhere to do my replacement. Using anything larger or smaller doesn't work

were the webco struts standard suit lowered,have an vz sv6,just checking,site says suits my car.first time i will be using webco.

Good video. Was there a "w" notch on the top strut plate? I've heard that has to be pointed toward the engine bay.

Hey mate ive changed my front suspension on my holden vu ute v6 and done it how u did it on the video and im not sure why but my top mount washer isn't sitting on the body like yours is. Could there be a reason why? Cheers

Great video. Thanks. Any chance you could provide the torque settings on the bolts ?

How do you know how much bolt / thread to leave protruding from the top?

did you put the bolts the right way through? I though the heads go to the front and nuts at the back of the strut?

Mate I just brought the same brand webco but mine don't fit and look little different to the old ones . It's been a while since you done this video but can you recall the part number?

Nice1....I just had mine replaced but now with these bs pot holes...1 side is damaged again....can I buy 1 separately or is it only available as a pair..thnx