How to remove and replace an old uPVC door handle 

Dont forget to Subscribe, every Sub helps the channel grow 🙏🤝

Hi bought a new security door handle all measurements are correct but when I tried to install the sections that go into the door to screw through are larger than the holes in the door. Can you just drill the holes bigger? It's a UPVC door.

Hi can you help with a question I have? How would one go about replacing a door handle a bit like the one in the video, however there are no visible screws and the door is permanently locked? I guess the locking mechanism inside the barrel of the lock has failed which leaves the door un openable. There doesn't seem to be an obvious way of replacing it without opening the door first to get to the screws and that isn't possible in this situation. Any ideas would be very helpful.

Hi, looking for some advice. I need to replace a UPVC handle, but the problem is the measurement between the screws is 116mm. I've trawled online and it seems the standard shortest length is 122mm. So I'm guessing I've got some obscure or obsolete handles. What do I need to do? Drill new holes maybe? Any advice would be appreciated, cheers.

Hi, my doorhandle is 76mm to centre but replacement door handles are 70mm then 82mm. I can't find ones that are 76mm. Any ideas??

why are the euro cylinders sticking out so much, shouldnt they only stick out 3mm? that looks 5mm

How do you convert a door handle set from offset lever and pad to level, lever lever?

Is it possible to drill the holes to match the screws? I got a new door handle 215mm space between the holes. When I tried fit there's about 2mm of a difference.