Dude, THANK YOU for this. That little rubber flap in the front groove was the culprit for me and I spent 2 hours trying to get this back on. For whatever reason, every single other video that shows the bumper removal neglects to show the re-installation and that is by far the trickiest part. For others still needing help: once the bumper is anchored at the top, wrap your fingers around the very bottom edge of the black plastic in the front and feel for a little thin rubber sheet. Hold that down and pull out/back until the sheet slides under the intruding part that rests above it. This was the trick that did it for me. The plastic intruding part of the car was in the fender groove that he mentioned but the little rubber sheet was bunched up and it blocked the front fastener holes from lining up.
I’ve been trying to put it back on for over an hour after putting a sport grill on and a splitter. Do you think the screws for the splitter would be an issue or prevent it from lining up right
There is not a camera on mine but there is a small piece that can be removed on the grille for the jdm camera. Not sure if there is a way to hook up the jdm camera
Noted. Thanks. Didn’t want any surprises pulling the bumper off a limited. Someone mentioned that the directional headlights operate based on a front camera.
@@NikNikJuice direction of the beam would be controlled by the steering angle sensor. The auto high beams are controlled by the front camera on the windshield/rear view mirror.
