How to Replace a Moen Shower Valve Cartridge 1225

Подписаться 57 тыс.

Просмотров 71 тыс.

50% 1

How to Replace a Moen Shower Valve Cartridge 1225 - Start to finish guide on replacing a single handle Moen Shower Valve Cartridge 1225.
DON'T FORGET TO LIKE COMMENT AND SUBSCRIBE
/ @diyhomesteadprojectsd...
As an Amazon Associate I may earn from qualifying purchases and no extra cost to you.
Moen 1225 One-Handle Kitchen and Bathroom Faucet Cartridge Replacement Kit, Brass
amzn.to/3uQHdj2
Danco 80360 Waterproof Faucet Grease, 1/2 Oz
amzn.to/4c4XYb3
Top videos you need to see:
How to Wire a Double Duplex Outlet - DIY (OFFICIAL VIDEO)
• How to Wire a Double D...
How to Replace Hard Wired Smoke Detectors DIY
• How to Replace Hard Wi...
How to Wire an Outlet Off a Switch - DIY Wiring Projects (OFFICIAL VIDEO)
• How to Wire an Outlet ...
DIY Homestead Projects contact email - diyhomesteadprojects@yahoo.com
WannaBFree Amazon affiliate link
www.amazon.com...
Link to my other channel with lots of camper van and travel videos
www.youtube.co...

Опубликовано:

16 окт 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 77

@DIYHomesteadProjectsDIYHP10 7 месяцев назад

How to Replace a Leaking Tub Spout with Diverter ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE-nQ-udWLmFEE.html

@OriginalRocketUp 2 дня назад

Thank you so much! Saved me $400 dollars + parts costs!!!

@DIYHomesteadProjectsDIYHP10 2 дня назад

Excellent!

@breeze787 5 месяцев назад

Thanks for putting this up! You are the only channel dealing with a Moen 1225 that has pointed out which way the cartridge goes in to get the hot and cold flow correct. So far no other channel has addressed that so I thank you. I put mine in backwards but your info allowed me to correct my mistake without total disassembly or even having to turn the water line off.

@DIYHomesteadProjectsDIYHP10 5 месяцев назад

Thanks for stopping by!

@jimmagoun2170 5 месяцев назад

Excellent video instructions. My mechanism was frozen tight- couldn't pull out the knob to turn on the water. I used your video to do the replacement. All went smooth and took about 20 minutes. Now our guests can use the guest bathroom to shower. Thanks

@DIYHomesteadProjectsDIYHP10 5 месяцев назад

Excellent! Nice Job!

@saulferguson8567 3 месяца назад

Thank you! I did use the puller and I put it in with the hole up but I turned just the knob 180 degrees and it’s just fine. The beauty ring is the stop on mine.

@clinneer 3 месяца назад

Thanks. Worked exactly as shown. Took me all of 15 minutes. And got the hot/cold right. Previous repair guy reversed them apparently.

@DIYHomesteadProjectsDIYHP10 3 месяца назад

Nice work!

@KENSJ Месяц назад

Thanks for the tutorial. I had my hot and cold reversed, but somewhere I read that you just rotate the stem 180 degrees before putting on the knob. That worked.

@DIYHomesteadProjectsDIYHP10 Месяц назад

That is correct 👍🏻

@SamuraiSith 3 месяца назад

Just fixed my bathtub faucet using your video! THANKS! The cartridge in my faucet took a little longer to get out... but I got it!

@DIYHomesteadProjectsDIYHP10 3 месяца назад

Great job!

@havfaith67 3 месяца назад

This is perfect. I have to replace my cartridge again, and needed a refresher. Also have to replace my plate and handle. Just hoping it goes as smoothly as this looked. 👍🏻

@DIYHomesteadProjectsDIYHP10 3 месяца назад

I wish you the best with your project!

@philandcarolgood-elliott6129 5 месяцев назад

Thanks. Very clear directions with little excess content. Much appreciated!

@DIYHomesteadProjectsDIYHP10 5 месяцев назад

Glad it was helpful!

@dannyn3154 9 дней назад

Thank you so much. Made this an easy job, that i originally thought would be so complicated. Much appreciated.

@DIYHomesteadProjectsDIYHP10 9 дней назад

Great to hear!

@karenpedraza5514 3 месяца назад

This video is 10/10! Really helped out when we replaced our cartridge. Thank you! Keep making videos

@DIYHomesteadProjectsDIYHP10 3 месяца назад

Glad it helped and thanks for stopping by!

@JaydaAndTheCat 6 месяцев назад

Thank you, sir! Most of the other tutorials only showed how to remove the cartridge with a puller... I REALLY didn't want to spend the extra money on something I'd only use once a decade! Your video definitely made me feel more confident doing this... but let's just PRAY mine comes out as easily as yours did!😂😬🤞

@DIYHomesteadProjectsDIYHP10 6 месяцев назад

Glad it helped I wish you the best!

@JaydaAndTheCat 6 месяцев назад

@@DIYHomesteadProjectsDIYHP10 It came out!!!!😃🙌

@DIYHomesteadProjectsDIYHP10 6 месяцев назад

Excellent! Nice Job! 👍

@Cedartree-cf6om 17 дней назад

Your vid helped my confidence. Only issue I have is I don’t get hot water now with the cartridge install. I do have a screw (not shown in your vid)that controls hot water, perhaps I installed it incorrectly?

@boblee9088 6 месяцев назад

Best video ever , you did it exactly the way Moen instructions said to, thank God I didn't need any puller

@DIYHomesteadProjectsDIYHP10 6 месяцев назад

Great to hear!

@Gdsmith504 3 месяца назад

Thanks, this came through in a pinch while fixing my mother in laws shower. I couldn’t figure out how to get the old one out. I gave it alittle twist on the body with some needle nose pliers and then it slid right out.

@DIYHomesteadProjectsDIYHP10 3 месяца назад

Excellent! Glad to hear you got it replaced. Thanks for stopping by!

@ezafm5410 2 месяца назад

This video was a huge help, thank you for sharing your knowledge!

@DIYHomesteadProjectsDIYHP10 2 месяца назад

Glad it was helpful!

@KimMelton1971 2 месяца назад

Thank you for pointing out the hole goes down .. my hot didn’t work and I think that was the reason

@DIYHomesteadProjectsDIYHP10 2 месяца назад

Thanks for stopping by!

@nimster64 Месяц назад

Good video I notice the hole was ontop but you installed it with the hole on the bottom. Did it make a difference?

@DIYHomesteadProjectsDIYHP10 Месяц назад

It’s been long enough now that I don’t remember for sure. Just know that if you temperature is reversed, turn the valve 180 degrees an you should be fine.

@musicjazzvez Месяц назад

Thank you for sharing I need to finish install mine!

@DIYHomesteadProjectsDIYHP10 Месяц назад

Any time! I wish you the best with your project!

@ODjuliarso Месяц назад

Thank you for sending this out here! Very informative ..

@DIYHomesteadProjectsDIYHP10 Месяц назад

Thanks for stopping by!

@spysweeper 23 дня назад

is the one with pressure control interchangeable with this type cartridge? Im referring to the one which equalizes the pressure automatically so you always have constant mix of hot and cold even if someone flushes the toilet...

@DIYHomesteadProjectsDIYHP10 23 дня назад

That's a good question but I do not know the answer.

@gerbermack 3 месяца назад

Thanks, man. Gonna try this tomorrow.

@elmandalorian6671 12 дней назад

Excellent video 📹!

@DIYHomesteadProjectsDIYHP10 12 дней назад

Thanks for stopping by!

@ToniCordero-m6w 9 дней назад

great how to video.

@DIYHomesteadProjectsDIYHP10 9 дней назад

Glad you liked it!

@scottkramer481 22 дня назад

when you pulled out the old cartridge, the hole on the brass part was facing up, and when you installed the new one, the hole was down. And you said that the temp was correct. Does it even matter which way the hole is pointing?

@DIYHomesteadProjectsDIYHP10 22 дня назад

I am not sure if it matters or not. If the temp is backwards just rotate the new valve 180 degrees and it should be corrected.

@Arthur-sz7uf 3 месяца назад

Very informative video. Thank you.!

@MrSnacko 16 дней назад

When you show putting the hole in the stem down, you know that the stem turns inside the cartridge? So, how do you know if the cartridge is upside down? Or doesn't it matter?

@DIYHomesteadProjectsDIYHP10 16 дней назад

It doesn't matter. If your hot and cold are backwards just pull out the valve and rotate it 180 degrees then put it back in.

@MrSnacko 16 дней назад

@@DIYHomesteadProjectsDIYHP10 I saw on another video today that you don't have to take the valve out if the cold and hotter backwards, just take the handle off and turn the stem 180°. I actually had to do that and it worked fine. Thanks for your videos!

@DIYHomesteadProjectsDIYHP10 16 дней назад

Excellent!

@Here-jy5fw 2 месяца назад

Thank you, just did it.

@DIYHomesteadProjectsDIYHP10 2 месяца назад

Excellent!

@jehovanygomez5890 Месяц назад

I installed the Moen 1225 cartridge but I have a problem with the temperature limit not stopping, defective cartridge or how do I solve the problem to pass inspection, thank you

@DIYHomesteadProjectsDIYHP10 Месяц назад

Make sure you install the metal beauty ring that goes over the cartridge before you install the control handle. The metal beauty ring is what actually stops the handle from turning too far, not the cartridge. I wish you the best!

@philipxie2009 4 месяца назад

Very good! Thank you so much!

@DIYHomesteadProjectsDIYHP10 4 месяца назад

Thank you too!

@kartencarter8135 4 месяца назад

Thanks for pointing out that the hole in the front of the cartridge faces down for hot and cold to end up on the correct side

@DIYHomesteadProjectsDIYHP10 4 месяца назад

No problem 👍

@Daniel-zq5hh Месяц назад

Strange, I did mine with the hole down and it hot/cold ended up being opposite to how they should. Fixed it by switching so the hole was up. Maybe my shower's weird.

@diesel5946 2 месяца назад

Never push directly in on the stem.It will push out the back side of the valve.It looked like it still worked.But you should not do it that way , but other than that great jobNever push directly in on the stem. It will push out the back side of the valve. It looked like it still worked, but you should not do it that way, but other than that great job.

@DIYHomesteadProjectsDIYHP10 2 месяца назад

Thanks for the tip

@velocityinstereo 2 месяца назад

Thank you.

@DIYHomesteadProjectsDIYHP10 2 месяца назад

You're welcome!

@PaulHynes-t6f 25 дней назад

Isn't Moen life time gaurentee.....? I never pay for my cartridges just exchange it......

@brianreinhardt4050 6 дней назад

Great job explaining how you cleaned it out...NOT!

@DIYHomesteadProjectsDIYHP10 6 дней назад

Mine did not require any cleaning so I didn't show how I didn't clean it.

@leomartinez2367 Месяц назад

My pullout is stuck. So i can't relieve the pressure. What do you recommend? Thank you for your video.

@DIYHomesteadProjectsDIYHP10 Месяц назад

You might be able to use the bathroom sink faucet to relieve the water pressure. They are likely on the same supply line.

@leomartinez2367 Месяц назад

Thank you so much for your expertise. I bought the 1225, but not sure it's the pull out. How can one know if it's a pullout? Your video is very good for DYIers

@DIYHomesteadProjectsDIYHP10 Месяц назад

The 1225 cartridge turns the water on by pulling the handle out and adjusts the temp by turning the handle from side to side. The 1222 cartridge turns the water on by turning the handle only and adjusts the temp by how far the handle is turned.

@ONWOTE 7 месяцев назад

Hello Bruce, this is ONWOTE, a manufacturer of PoE and Wireless Security Camera Systems. We sincerely to invite you join us to to install and test our camera system. Secuirty is everyone concered about and you can make a honest review for your viewers. I had emailed you more details and waiting for your kindly reply. Thanks.

@DIYHomesteadProjectsDIYHP10 7 месяцев назад

I'll see if I can find your email and check out the details. Thanks