How to Replace Fuel Injectors on V6 engine (1998-2002 Honda Accord and Acura 6th gen) DIY 

BEST AUTO REPAIR VIDEOS ON RU-vid!!! I'VE WORKED ON MY CAR AND MADE MIRACLES HAPPEN, JUST BECAUSE OF IGOR! NOBODY MAKES BETTER VIDEOS HANDS DOWN! SCOTTY'S GOOD, BUNDY'S GOOD BUT IGORS STEP BY STEP VIDS ARE SECOND TO NONE!!

Also, when put back fuel injection rails, turn key on to engine, fuel pump works to see if any injectors are leaking. Now's the Time to check! Don't be a cheapo, buy New o- rings for injectors, and all gaskets needed, including throttle body. Also clean intake and paint! Nice looking when done!

Excellent vid. Very satisfying to watch.

Bro, this video was very informative. I have a 2000 Accord with a fuel injector problem and this video alone literally helped me out. Thank you so much for this video ❤️

Just changed them. Thank you for the video. Very helpful.

Negative battery cable comes off First, goes on Last. Pull fuel pump fuse and start engine till quits. Overall, Great Vid!

Thanks Igor for the great info and edited video. Best video I seen on auto maintenance. For my 1999 Acura TL.

Thanks this video helped me a ton unfortunately taking off the manifold bolts I broke 3 but it seems ok . Definitely feel the fuel now my car was running very lean . *subscribed*

very good video tks help me a lot.

Thanks for saving us all money

It's a great clip.

Great video!

how on earth did you get the fasters for the back fuel rail back in with that valve cover still on?

What about the thick seal ring that goes on the bottom of the injector?

Before starting this whole procedure how do you depressurize the fuel line to the injectors so you don’t get gasoline everywhere? Do I just unplug the fuel pump relay/fuse or is there more? Thanks!

Awsome video. My engine is running lean and there is a raw gas smell so I'm going to check them right away. Thanks ;)

This video was amazing and so helpful will be subscribing

@Igor: awesome work brotha! Amazing tutorials!! Possible u make one on how to replace a fuel pressure regulator for a 1999 Honda Accord EX V6? Thanks!

Hey great video! I have the same car and when I crank it it turns over but takes a second to crank . However later if I drive and park it for 30min to a hr it cranks up do you think I should replace the fuel injectors aswell

Only clean 1 side throttle body? Also, buy an LED Light. Your Thomas Edison bulb could cause 🔥. I would take apart Everything you took off that mated with a gasket. Cleaned up intake manifold and Paint. Also can upgrade COPS. eBay has higher voltage replacements. The tube that goes from throttle body to air cleaner can be broke where meets throttle body, looks ok until you take off, mine was broke all around where clamp is, can't tell unless you check. Air leak! Why I take off as much as I can in area I'm working on. Can coat all Used gaskets with a good gasket maker compound, when put back on. Tube from throttle body to air cleaner is $22, new, eBay. 😀

kool!!

Great video. My question is; what was the symptom with the car that prompted you to replace all six fuel injectors rather than clean them up? They are very expensive, and what brand did you use? How is the car performance so far? I have a 2000 Honda Accord V6 that I feel like it's hesitating lately.

Where do you get your fuel injectors?

Can you reuse the intake and plenum gaskets.

Hi I have the 98 V6 Coupe I replaced the fuel regulator, fuel injectors. When I start the car it idles low and heavy fuel smell. I replace charcoal canister , and cleaned out throttle and replaced EGR and cleaned manifold. I also have coolant leaking from timing belt maybe water pump. I haven’t been able to check yet because if I let off gas the engine stalls

I have 2000 tl 3.2 i replace the plugs and coils an i still get misfire in #5 gas smells when the heat is on engine spudder with take off idle and accelerate

After cleaning the throttle no need to erase any code Because I have done mine then come a check engine

I replaced all fuel injectors exactly like in this video, now I have flashing check engine light after doing this. I used code reader and am getting codes p1399 p0300 p0301 p0304 and p0306, all misfires. Has this happened to anybody after changing out fuel injectors? Did I damage a gasket? There was no check engine light before replacing injectors. Car turns on, has a little bit of a shake, shakes more when I press gas to 2000 rpm while in park, smells a bit like gas, and has a little bit of faint smoke from exhaust.

I took my throttlebody and pleum off and cleaned it put everything back together now the car is running at high rpm its over 3,000

your car whistles