How to replace ignition lock with no keys on a 1988 Ford F250

Подписаться 1,1 тыс.

Просмотров 19 тыс.

50% 1

If you are trying to replace an ignition lock cylinder and you have no keys on an older ford (some other vehicles too with no side bar) you can rake or pick it open instead of drilling
This principal is the same when it is installed in the truck- customer did not want me to film, so I could not demo this while in the truck
This works if your column has a hole (ejection port)
If your model doesn’t have an ejection port hole, then you’ll need to remove the steering wheel, or plastic column
This video shows while in truck removal
• 1980's Ford Ranger Rep...

Опубликовано:

12 сен 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 17

@PocketWomen Год назад

Cool demonstration. Good to know the trick with the retaining pin. Picked that lock so fast with that rake, Cheers

@feelvivek 8 месяцев назад

was that an OBS or a bullnose ? I kept raking with no results on a Bullnose (1980-86), lol

@thewhittierlocksmith121 6 месяцев назад

@@feelvivek OBS

@rmsg7504 Год назад

I didn't know those would pick, awesome! I have that same pick set. Also learned from this how to tell side bar. Thank you

@RuggedArtistry 7 месяцев назад

Can you send a link where you purchased those lock picking tools?

@thewhittierlocksmith121 7 месяцев назад

Goso lockpick set. I’ll try to find a link

@mwaage1127 Год назад

I need replace my key cylinder. What is the rake that was used?

@thewhittierlocksmith121 Год назад

Just a cheap double sided rake-

@HDavidMahan 22 дня назад

Where do I get that pick tool?

@thewhittierlocksmith121 22 дня назад

@@HDavidMahan most locksmith distributors have them or Amazon may have them. It’s a double sided pick

@timelordnoah5179 10 месяцев назад

Link?

@feelvivek 8 месяцев назад

Hello does this work on a 1980-86 ignition key ?

@thewhittierlocksmith121 8 месяцев назад

It should- if the ignition hole is centered

@feelvivek 8 месяцев назад

@@thewhittierlocksmith121 thanks I tried for a while. Do some key pattens just not rake ? Also does it get harder with age, if the lock pins are worn down and slip too freely ?

@thewhittierlocksmith121 6 месяцев назад

@@feelvivek yea for sure, use lube like houdini or tri flow- some of these locks are older than i am and there's tons of old grease, gunk and dirt. Ignition may even be bad if it doesn't work. Just try a few different rakes, picks and or jiggler keys

@thewhittierlocksmith121 6 месяцев назад

@@feelvivek to answer your question, sorry for late response. Yes some patterns may not work, may need to try different combos of rake shapes