..I used 6mm stainless pan head screws to do my front door handles. Seems more than sturdy enough, looks fine and since Tesla wasn't involved they shouldn't rust. I did double nut them with lock washers on the back. They're not hard to reach. It looks like i can get by with the rear doors. I'll post again if I'm wrong. 😂
The center pin is steel. The rivet is aluminum. The center pin throws your drill off center and is very hard to drill out. It is a mistake to rivet these handles back in. Just use a couple right sized sheet metal screws in case you must again remove the handles.
What size is the appropriate rivet to use to install these back on? I have a 1998 ranger and can’t find which size rivet to use? What size did you use for this? Thanks