How to reset 370z & g37 check engine light 

What I did was basically follow his steps while the video played and counting in my head to be sure enough time passed but definitely helped me out and the service light is gone I’ll see in the morning if it holds (I have a manual 370z worked fine)

This worked on my G37 2009. Thanks. *I had my check engine service light on because I replaced my catalytic converters with straight pipes, so the sensors were left out unplugged*

Did this on my 2018 Z, took me 15+ tries. It's all about timing and knowing the instructions. You can do it, just might take a minute

Awesome. Wouldnt have done it without this amazing and easy tutorial. Thanks kindly

*please use a timer while doing this, do not estimate the time Turn the ignition key to position “ON” without starting the engine and wait 3 seconds. Fully press and release the accelerator pedal five times within 5 seconds. Wait 7 seconds Fully depress the accelerator pedal all the way to the floor and hold for ten seconds. until the CEL starts blinking. At this point, the light CEL should start flashing error code stored in the system and you can release the pedal. If you only get five flashes slowly or not flashing at all, then it is time You went on one of the above steps and you have to start from scratch. Fully release the accelerator pedal (while the CEL is still blinking) and wait about 10 seconds. Fully depress the accelerator pedal and keep it for more than 10 seconds. Fully release the accelerator pedal (The CEL light will continue to blink). Turn the ignition off and start the engine to verify the indicator has been reset.

This works on my 2017 370z Nismo. Thank you awesome.

Thank you. this worked after 4 tries. however my service engine light came back on 30seconds after I turned the car on.

Its do cool thank you!!!! My engine oil sensor has a problem and now it's working and could erase check engine light! Greetings from Luxembourg, happy new year!

Does it matter what year it is cause I have a 2016 and I’ve tried this multiple times and it doesn’t work unless I’m doing something else wrong

Is real good work for me thank you

Thanks so much sharing! I was able to reset the CEL on my husband’s Nismo!

Thank you bro

Thanks again for sharing. Your notes worked perfectly.😎

Why was the check engine light blinking

FRESH!

It's same in manual transmission?

I have a check engine light due to my test pipes, will this hide the code when reading it with a obd2 scanner even though the check engine light is now off?

How does the 370z low tire pressure light turn off?

Did not work. My car keep stop blinking