How to set up your PTZOptics MOVE SE Camera 

For the PTZOptics MOVE SE camera, integrating a digital mixer with the camera to enhance audio quality is a common practice, especially for professional or semi-professional video production setups. Here's how you can do it: Connecting a Digital Mixer to PTZOptics MOVE SE: Use the 1/8” Line-In Jack: The PTZOptics MOVE SE camera comes with a 1/8" (3.5mm) line-in jack for audio input. You can connect the output of your digital mixer to this jack. If your mixer has XLR outputs, you'll need an appropriate cable or adapter to convert XLR to 3.5mm. This is typically an XLR to 3.5mm TRS cable. Audio Interface Consideration: An audio interface is not strictly necessary if your mixer can output a line-level signal compatible with the 3.5mm input of the camera. However, if you're experiencing issues with audio quality or compatibility (such as impedance mismatch or level differences), an audio interface can be used to better match the mixer's output to the camera's input. Setting Levels: It's important to adjust the output levels on your digital mixer to match the input sensitivity of the camera's line-in. This helps in avoiding clipping or too low audio levels. Test and adjust the levels to ensure clear audio without distortion. Balanced vs Unbalanced: The 1/8” line-in on the camera is typically unbalanced, whereas XLR outputs from mixers are balanced. Using a cable that properly converts balanced to unbalanced signals is important for maintaining audio quality and reducing noise. Audio Monitoring: If the camera allows, monitor the audio through the camera to ensure the sound is being captured as expected. Adjust any necessary settings either on the camera or the mixer to optimize audio quality. Firmware and Software Updates: Ensure your PTZOptics MOVE SE camera has the latest firmware updates, as updates can sometimes improve audio handling capabilities. Check for Ground Loop Issues: If you encounter any humming or noise, this could be due to a ground loop. Isolators or ground loop eliminators can be used to resolve this. Additional Tips: Audio Sync: If you’re also capturing audio directly on your computer or another device, ensure that the audio from the camera is in sync with your video feed. Cable Quality: Use high-quality cables to minimize noise and interference. Consult Documentation: Refer to the PTZOptics MOVE SE manual for specific instructions and recommendations regarding audio connections. By following these steps, you should be able to connect your digital mixer to the PTZOptics MOVE SE camera for enhanced audio quality in your productions.

There a couple ways to do that today. You can put the camera on an outside IP address OR use the NDI Bridge.

Yes, you can. Our NDI bridge video will be released on October 25th at 2 PM. Turn that notification Bell on to see when it drops!