How to setup / tune your servos on a Losi 5ive T 2.0 

Glad it helped you out Bro 😁👊👊

Thank you for the feedback brother 😁👍

Thank you very much! I appreciate the support!

Thread in the thumb screws off the breaks, use equal turns in on both until you are happy with the breaking power

Futaba

Futaba 7PXR

@@largescalercnation thanks man for reply yes I will see soon which one best for losi 5t 2.0 some people say dx5c. and dx5 pro I m confused I need for low price anyway let me see thanks again

First discount the servo horn and verify that it fully moves left and right freely. Next. With the servo horn off turn your controller L/R steering trim to 0 (center) then reconnect the horn as close to center as possible. Reset the endpoints to full and then dial it back. You should have found the problem by this point. There my be a pebble stick under the front chassis plate and drag link Also check to see if your servo saver is too loose, check the action and see if it stays solid while turning or if the lower arm connected to the servo linkage moves more than the upper section of the servo saver

Considering it goes both left and right, it’s not a trim issue, either something is binding, something is loose or the servo is defective. Center the servo horn, remove the screw and horn from the steering servo, then this will allow you to move the front wheels with your hands left & right. If no binding, check and make sure your servo saver is not too loose refer to the Manuel. Not turn on the radio & truck and turn the steering left and right while disconnected. See if it lands center by watching the servo teeth. Mark a line if needed. Reinstall the servo horn and hold the servo horn and try turning the wheels, if they move… your servo saver is too loose. This should give you the answer by performing these test. Good luck. Probably the servo saver is too loose though

Make sure all hardware is tight in the steering and the rest of the car. I’ve heard cases where screws were loose. Take the time and do a once over.