How To Tell If DTF Printhead|Cables Are Out | Red Light Of Death 

I have the DTF Station Prestige A3+R. Replaced the printhead and printed a few jobs with no issues. The following day I hit print, and no ink. I check the side of the printhead and see the green light and a red one, too :( I'll try swapping out the cable.

What's your color damper color configuration? From left to right?

My ink light is on my printer I have pressed it multiple times will not go off. Says something about the cartridges needing replaced it’s only 3 months old r1390 a3

So there can be mutliple things the most common would be Bad print head, Bad cables and Bad fuse on the main board. Alot of times if a cable goes bad or a print head goes bad it can take all 3 with them. MOST of the time if the print head goes bad from a short it pops the smd fuse on the board. So if you replace the board or replace the fuse but not the bad head, you can repop the fuse. I do micro soldering repair and refurbishing on alot of these boards. Its really handy to get you a simple multimeter to check fuses too.

Have you ever experienced your prints coloring just all of a sudden printing wrong. I was printing a couple of images one night just fine and then I went to print a rose design. The hue was way off. the green leaves came out super neon yellow and the red was a bright weird coloring as well. I did everything cleaning wise to this machine and its still happening. I just don't get how one image is fine and then not even a minute later then next does this. I can't get it fixed either. I can print black and white images not a problem. But it seems to be something with the color. Any help would be appreciated! Thanks!

Please advise on where to find these flat cables? or the whole power section? UNINET 1000

What did you end up doing after this video, Did it end up working? I am in the same situation. I connected a new white printer head and now the red light shows up and nothing prints. I ordered new cables but they haven't come in yet. Any suggestions.

How do I reattach my line what kind of tape do I buy

hi, when you print from your DTF, how do you get the white ink to show after it is finished printing? I have a DTF printer and I use the direct to film, digital factory and my print only print the color but not the white. the white only come out clear. I can only put the prints on white shirts not blacks. can you help?

Wondering if I can get some advice here… so I replaced my color printhead on my dtf procolored printer… stilll not printing… could it be the motherboard or do I just have to do a few cleaning cycles? 😢help

Bro this is the worst thing that I've ever came in contact with. I trusted those at procolored for 7.3k and there's absolutely no returns and I'm about to junk the while x600 dual head system.