How to test BMW Transfer Box Code 5F3A X Drive 

Good video, thanks

Great Video

Thanks for sharing ADP👍 Really valuable information👍

Hello, 2011 model BMW x6 car gives this fault code: 5F39 4x4 and ESP ABS fault lights are on

I had the abs,brake,and 4x4 light on the dash. I replaced actuator and tore apart old actuator and found plastic gear stripped. Well two weeks later the lights are back and they come on every time I drive it. When I first replaced it I was getting a clunk noise when taking off fast, but no clunky when taking off slow. Front end sounded like something was worn. Now that lights are back on I hear no clunking sound. What do you think is going on

How about resetting the adaptation on the VTG module, say after an oil change on the transfer case? Can the Autel do this?

Hello changed the actuator and resistor myself on my x3 and it feels much better and lights gone but feels like its dragging sometimes i have the code “54C4 First calibration defective” Reset it with basic scanner and the code comes back do i need a special scanner is my transfer case bad? Thanks...

Hyy,I have the issue with Dsc abs brake light on I change transfer case actuator ..change abs module and yaw rate sensor..Right now my light is off and I drive 10 miles before I turn hard left they come on again and I feel like some braking behind..like some one push on rear brakes

Without oil,does the transfer case turn on the service engine soon?…thanks in advance.

I replaced actuator. Now when in gear I get a bad grinding noise...even at crawling speed 1-2mph. With actuator unplugged veh drives fine, no noise. But no 4wd either. Gear oil was low when I did actuator. Any thoughts on next steps?

When on x3 turning on full lock transmition feels like its fighting crabbing rear wheels trying to spin with this faukt code is it the gear

Hi, please if u can help me in my x5 2004. From a while The trifecta lights with dsc inactive came on, so i went to a mechanic that showed in his scanner the gearbox so i changed the gear with the actuator and new oil but it’s used and it’s spare parts from an x5 in japan. Anyway after changing it sometimes the dsc only comes on but when you turn on the car again it goes off. So i scanned the car and it gave the steering angle (code: 04 and 08 slider fault, adjustment operation) with the transfer case(code: 54C8 classification registor). So he told me u should change the steering angle, is that true because here in ur case did u change the steering???

BMW X6 2011-2012 when it turns left or right it doesn't make any noise but it feels bumps, but in a straight line it's normal, what could it be?

Any help will helpfull thank you

Does anyone out there know where to buy the parts to rebuild these transfer cases?

Hello, I have a 2005 bmw X5 with the 4x4 light on the dash. I changed the gear on the actuator but the the light is still there. I noticed the vehicle cannot be driven for long as it goes into limp mode. I have to shut it off and then restart

when this happen to me and it was the transfer case module under the front passenger seat carpet small silver box by the sub woofer speaker on an 2008 e90 so what i did i order this thing called xdelete and flashed out the transfer case so now its rear wheel drive untill i get some funds to fix it

Cool video, but my tracking must be off