How to upgrade from a baseboard to a wall heater | Cadet Heat 

"...my measurement was not perfect" he says. I'd say: "he fucked up the wall!" 🤣

Is it possible to place one of these wall heaters near to the wall thermostat for the old baseboard heater? I don’t know much about how those two are wired together, but I assume the supply wiring must connect at the thermostat somehow?

They make a push-in strain relief connector for Romex cable. It's called a hit connector.

What's the most energy efficient baseboard heater upgrade on a budget?

Just finished swapping 2 baseboard heaters and I was amazed how easy it has been so far. My question is what to do with the insulation? Best to cut it out or shove to the bottom? Thanks for the Video made life easier! I am amazed at the heat produced by these little units!

Curious, I installed both units (That have thermostats) and I also have a Thermostat in the wall as well. I noticed below you told Ashley not to mix the two will I be ok? Thanks

I had two 8 foot 240 volt baseboard heaters...each was 2000 watts 8.5 amps and both were wired to be controlled by a thermostat on the opposite wall. I chose two of the Cadet CEC 163 TW Energy Plus Multivolt with thermostat...one to replace each baseboard heater. The room is 12 x17 but has several large windows and a cathedral ceiling with a ceiling fan and a wood burning stove as the main source of heat. I wanted a back-up source of heat just in case I can't use the wood stove for some reason. The wall heaters will be at almost opposite ends of the room. I put one of these in my bathroom, which was pretty simple because that baseboard heater had an on, low, med, high, off heat dial thermostat on it. My question is, do I need to wire-cap my thermostat wires in a specific way so it allows my wall units to function correctly? Each baseboard had a black, white and bare (ground) wire. My thermostat has several black and white wires and a red wire. I'm confused by the red wire and if I should pair it with a specific color wire(s). It gets very cold here at times (-15- wind chills), so I'd rather have enough heat and run them more efficiently/independently, than not enough heat and have to run them with an increased fan speed to maintain the temp. That wall thermostat confuses me.

The small baseboard heater I would like to replace has a thermostat on another wall. If I were to do what you did in the video, what happens to the thermostat?

Can you use the old thermostat for that cadet upgrade

I have a hot water heater can i replace to electric board heater??

3:28 - Whoopsie daisy!

if there is one thing I've realized from these videos... it's I suck at cutting out holes in drywall...

They both look like Electric. Not in gas?

I wonder how much more cost efficient this is. my moms house has baseboard and its $$$

Im confused, where does the heat come from with the wall unit?

what in the world kinda room is that little wall heater supposed to warm up?

Cut twice and measure twice??