Hubsan zino mini pro gimbal fix but disconnection issues 

Active air plane mode on smartphone and try

The disconnection problems has been an issue since the Zino pro and pro plus! If you put your phone in to airplane ✈ mode it will not disconnect.

Is there an active hubsan group where I can find assistance with the drone? Many thanks Zino pro is always showing aircraft disconnected. Any help will be appreciated

Cut a little bit of the plastic from the usb cable I did that and it works fine

That is happening because it is a Hubsan. Not surprised they havent fixed this as it has been an issue on Hubsans since the first Zino

Friend I have the same problem with my Zino Mini Pro after the last update. Now the connection between the aircraft and the controller has stopped for good. Did you manage to solve this problem with your ZMP?

Can you fly this drone without using gps mode? My drone can’t find the gps signal any suggestions?

I'm also facing the same issue. People keep telling me that the cable is bad, I have to take my phone cover off and so on and so on. This is not the issue with the cable. If the cable is bad, then the disconnection will be only between RC and phone, BUT the RC also lost connection with ZMP. Totally lost control of the drone even it's only a few meters away.

How did you fix the gimbal issue?

Bonjour, pour éviter les déconnexions il faut couper le wifi du téléphone ou utiliser un cordon OTG de bonne facture (blindé). Si vous garder celui d'origine coupé le wifi du tel. et ne faite pas passer le cordon entre le tel et la radio (plutôt en arc de cercle vers l’extérieur.)

fly with cell phone in airplane mode and have no problem

Its written in the opening screen to enter “Flight Mode” to prevent connection issues. Airplane mode was lost in the translation.

I have another Hubsan Zino Mini Pro gimbal issue. The error message "Gimbal is under protection, please check if the gimbal is stuck". I have contacted service center back and forward through email more than 23 times, but the issue cannot be fixed. I repeated to remove the cables between the gimbal and mainboard again and again for more then 5 times, even I followed the instruction which they sent me the video. It doesn't fix the gimbal issue. Firmware has been updated and all the feature and function are working probably except the gimbal issue. I don't know who long I have to wait for the solution of this issue can be fixed. Just want to share the issue I am facing and hope that the Service center needs to make more effort to fix the customer issue.

Me too having USB disconnect problem, but only on ground . Yesterday did updates and connected without problem. I thing it's phone problem with security app monitoring ...

Change cable usb

Good vide!

There are many trees around you, you should fly to an open place.

hubsan being hubsan.

Fly airplane mode you can get better flying experience.