Bless you for all the educational content. It feels like I am in an operating room with a brain surgeon!!! You have made so many educational videos, all generations can learn from all your videos!!! Happy Birthday, God Bless!!!
Just subscribed!!! Heard about you from Wes Mitchell and finally came across one of your videos. I traded around and ended up with a ported 2018 Husqvarna 372xp xtorque. Happy Birthday and God Bless
hi bellhopper,happy birthday to have any cake,put that chainsaw back together ha,I'm workin on snowblowers just got one mower to do,then snowblowers just maintance stuff,ok bellhopper have a good one.
Happy Birthday Hopper!!! I usually cut the square so that fresh air will mix with some fuel mixture and get the oil in it so it’s not slamming the hot pistons like old Walt from Allfleetcommand does them…. I just started trying to use those Xtorq topend’s… got four I was going to just drop an aftermarket topend on but I’m going try on of the ported version’s first… hate to loose all those intake parts????
I have found that the squish is always tighter than the solder indicates unless using solder that is very close to the squish clearance. Your solder said .024", but it was very likely much closer to .020"