Ideal Logic Boiler Ignitor Unit Replacement: L2 Fault Code Repair

Подписаться 1,9 тыс.

Просмотров 2,7 тыс.

50% 1

Follow these steps to replace your Ideal Logic boiler ignitor unit in this no nonsense DIY video tutorial.
Ideal boiler L2 fault repair - Full guide housewarm.co.uk/ideal-boiler-...
An Ideal ignitor unit is a spark generator which fails quite often and is a common cause of an L2 fault code on an Ideal Logic (and some other Ideal boilers).
This is a very simple boiler repair with only one screw to remove and two plugs to pull off once the case is removed.
✅ Buy me a coffee ☕️ 👍 www.buymeacoffee.com/housewarm
Tools and parts on Amazon:
• Ideal ignitor unit (part number 175593) amzn.to/48jZLpD
• My Wera ratchet screwdriver amzn.to/3QpWaAh
If you buy through these links, I may earn an affiliate commission.
Video chapters for easy access:
00:00 Removing the casing
00:52 Removing the ignitor unit
01:27 Fitting the new ignitor unit
02:26 Refitting the casing
03:19 Testing the boiler
Get an experienced boiler repairer in Newcastle upon Tyne housewarm.co.uk/central-heati...
#centralheating #Housewarm #boilerrepair

Хобби

Опубликовано:

25 июл 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 10

@Housewarm 2 месяца назад

Buy me a coffee ☕ 👍 www.buymeacoffee.com/housewarm

@steveincork3669 Год назад

1st logics around 2012 had the ionisation lead attached to the spark generator which I was unaware of thinking lock out after ignition was pcb fault. Found this out later on an Ideal training day. Hard lesson

@Housewarm Год назад

One you'll never forget mate. The nightmare jobs typically turn out to be the biggest learners

@none-qq9lg Год назад

Going to replace boiler, I've been told it could be faulty fan, blocked main heat exchanger or the ignition lead, tempted to replace the lead given the small cost but not convinced it's that. Condensate is fine no blockages

@Housewarm Год назад

You need to confirm that you're getting gas at the boiler

@none-qq9lg Год назад

Replaced ignitor unit, PCB, gas valve and ignition electrode, condensate not blocked, I'm stumped, any ideas?

@Housewarm Год назад

Are you getting gas at the boiler?

@none-qq9lg Год назад

If problem persists after replacement, is it likely to be the gas valve or PCB?

@Housewarm Год назад

It could be but the first thing to make sure is that you're getting gas and the condensate pipe isn't blocked. It could also be the spark electrode or flame sensor or the leads. Can you hear it clicking when trying to fire up before it goes to lockout after resetting it?

@none-qq9lg Год назад

@@Housewarm condensate is fine and the spark electrode and sensor although never replaced, visually look in good condition. I've given them a clean