Installing an EMG Kirk Hammett Bone Breaker active pickup system. 

Best emg solderless tutorial, thank you man!

Awesome , thank you for this

Bought the hetset right after watching this. Excellent video from someone who knows what he’s talking about. The cherry on top was the test at the end. Very, very helpful.

Excellent video again! I love seeing someone else who hates messy wiring. Very nice work sir.

Thanks a lot! Nice and helpfull

So I just was able to realize my dream... it was to rebuild/upgrade a guitar. I was able to do all the upgrades except I couldnt find a wiring diagram for the same exact switch u had in this video (it's what I have but just couldnt find research on it) Thanks to your video I was able to know what contacts to solder and now have a guitar with a heck of alot more life and sass!

Wonderful video. Thanks for taking the time through the install!

RX Thank you so much for this video! I have watched many on the subject and none were as clear and thorough as this. I have a guitar repair company and I am struggling with all things electric. I learned a ton from you.

Thank you for taking the time to create this tutorial. I am going t be setting this exact setup in my Guitar. Very helpful, thank you.

Dean is awesome

Thanks for the video my set should be here tomorrow!!

Thank you so much for this video gonna use this for help when i order these pickups the first of the month

Good video thanks

If You don't want solder anything, better buy 3-way selection switch..😊EMG then just connect wires with quick connectors and is done.

I didn't need to solder anything. I just left the wires on the switch. They go into the bus. It says it on the instructions.

I finally purchased a couple EMG pickups an plan to follow your video the best I can. They haven't arrived, but I am noticing that the distance between the jack and the cavity with the pots and battery is farther than the measurements EMG states that their cables are (I have a Jackson King V, so the jack is on the opposite side of the guitar). Do you typically add an extension in this case? Thanks again!

How can i do the back plate on magnets?

not sure if this is a late comment but if i had a three pickup guitar should i just desolder the middle pickup and use the wires for the neck and bridge for the battery buss?

Is there any way you can do this without a saw during iron

Aprox. How much time the battery Lives? Even if you unplugg the cable?

Do you follow the same instructions for a three way toggle switch on a Les Paul?