Installing drive belt on craftsman garden tractor

Подписаться 4,2 тыс.

Просмотров 14 тыс.

50% 1

This is a craftsman garden tractor from the 90s. It is Hydro and we are putting a Drive build on.
#Gardetractor
#Repair
#Gardentractorfrontendloader
#Lawnmowerrepair
#DIY
#CarryAll
#CraftsmanMower
#Wheelhorsegardentractor
#JohnDeere
#mowerrepair
#smallenginerepair
#lawnandgarden
#craftsmanlawnmower

Опубликовано:

4 окт 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 29

@inthebackyardwithdel438 Год назад

Very nice install . The drive belt came off my Husqvarna . I will be doing a video on that later today !!

@MurphyMower Год назад

Looking forward to it 😀

@MurphyMower Год назад

And keep Cool

@hipdaizii Год назад

Me too, looking forward to it too

@hipdaizii Год назад

Good they put label for belt routing, a fella could get confused pretty quick.

@MurphyMower Год назад

Correct, the belt can go 10 different ways, I believe

@bobrebera494 2 месяца назад

Good job

@MurphyMower 2 месяца назад

Thanks, and thanks for watching

@bigsonslawncare Год назад

First time I did this on a Troybilt was a total disaster 👍🏽

@MurphyMower Год назад

I hope it wasn’t too bad, but one time I did this and put it in drive and it went backwards These are easy to mess up

@Turningwrenches85 Год назад

Good work lee glad u were able to get it going again with the new drive belt. kohler engine sounds good on it also.

@MurphyMower Год назад

Thanks- it’s a smooth machine

@mariospano-hl5mb 5 месяцев назад

I have the same type of craftsman tractor, replaced the drive belt according to your instructions but the tractor does not move. The pin at the back of the tractor is engaged. Any advice on how to diagnose this problem?

@MurphyMower 5 месяцев назад

Is your gears or Hydro?

@mariospano-hl5mb 5 месяцев назад

It's a hydro

@MurphyMower 5 месяцев назад

Are you familiar with the switch on the back that we will disable the Hydro from moving?

@mariospano-hl5mb 5 месяцев назад

Yes I disabled the hydro so I could push the tractor. Then I engaged the hydro by lowering the pin.

@mariospano-hl5mb 5 месяцев назад

How would I know if the transmission pump has failed? I was moving and the tractor stopped moving forward, I knew the drive belt had some cracks and was worn.