Intex Excursion 4 boat set up with floor modification, box seats and Bison 40lb motor. (2 of 2) 

Will try and post something later. Cheers

@@leabetts4012 Thanks

Hi. Sorry it's taken so long to reply, and thanks for the compliment! I used 12mm ply, measured the internal dimensions in several places as it changes width from one end to the other. Once it fit in the boat (not too tight, allowing for the carpet) I cut it into 4 sections. Then, with 12 x chrome fire rated quality hinges, with no sharp edges (4 on each of the 3 joins) I hinged the center one opposite to the two either side so it could fold in a W shape. I used thick screws that went through the board and with an angle grinder, ground off the screw spikes, flush with the wood. Then, spray glue mounted van lining carpet to both sides, wrapping around the edges with extra glue, and trimmed. Blow up just the floor section of the boat first. When fitted, I slide pipe lagging foam tubes around the edges, before inflating the boat around the floor. Hope this helps.

Hi. Sorry it's taken so long to reply, and thanks for the compliment! I used 12mm ply, measured the internal dimensions in several places as it changes width from one end to the other. Once it fit in the boat (not too tight, allowing for the carpet) I cut it into 4 sections. Then, with 12 x chrome fire rated quality hinges, with no sharp edges (4 on each of the 3 joins) I hinged the center one opposite to the two either side so it could fold in a W shape. I used thick screws that went through the board and with an angle grinder, ground off the screw spikes, flush with the wood. Then, spray glue mounted van lining carpet to both sides, wrapping around the edges with extra glue, and trimmed. Blow up just the floor section of the boat first. When fitted, I slide pipe lagging foam tubes around the edges, before inflating the boat around the floor. Hope this helps.

@@leabetts4012 Thanks for the detailed instructions.

@@leabetts4012 so when you wrap both sides of the carpet around and glue them, do they just overlap? Really love your design want to do one for myself. Also you wouldn't happen to know the dimensions of the boards would you. Thank you :)

Nice floor ! You can also cut the grass hehe

Hi. Sorry it's taken so long to reply, and thanks for the compliment! I used 12mm ply, measured the internal dimensions in several places as it changes width from one end to the other. Once it fit in the boat (not too tight, allowing for the carpet) I cut it into 4 sections. Then, with 12 x chrome fire rated quality hinges, with no sharp edges (4 on each of the 3 joins) I hinged the center one opposite to the two either side so it could fold in a W shape. I used thick screws that went through the board and with an angle grinder, ground off the screw spikes, flush with the wood. Then, spray glue mounted van lining carpet to both sides, wrapping around the edges with extra glue, and trimmed. Blow up just the floor section of the boat first. When fitted, I slide pipe lagging foam tubes around the edges, before inflating the boat around the floor. Hope this helps.