Introducing the NTB7L BreakFree® Power Tube Bender 

Looking good ！

Good job AK

wow good to see you again ak. hopefully you can upload videos again on your personal channel @

Might have to grab this add it to my navac swaging kit. Only thing I wish was it did past 90. I 180 power bender would be game changer or one that dude hard pipe like the rems

Sounds like it really struggles with the reverse bend. Kinda makes me worried about the lifespan of the tool. I hate to be pessimistic because this is a very very cool tool!

Awesome 🤟💯🌎

Will it bend 3/8 stainless .365?

Hey I see this tool makes a nice 90 degree. But can I put a mark on my cooler then know where my bend will be? Or I just have to bend then cut my copper to fit in place?

And everyone ask about other material and radio silence we guess just soft Cooper

Hey Andrew question is this unit for sale yet??

Ok well i build and plumb auto car wash equipment. I work with 1/2" and 3/4" stainless steel tubing, you say this is just for soft copper? I bend ALOT of stainless tubing by hand, not a ratcheting crossbow but just a hamd bender, if this could bend my stainless id buy immediately

What's the comparison on the radius to a ratcheting. Same or little tighter.

Is this work for emt conduit?

This thing is already $488 and still without the revese bending accessory is too expensive

Does this ever kink the copper?

It doesn’t work for reverse bend I try it couple times and mess up my copper or I get a defective piece?

This machine do pipe ripe L?

此產品哪個國家製造？

Giveaway???…

😍😍😍😍😍