It exploded within 30 seconds... ($100+ Unboxing from TheCubicle!) 

If your curious now they have fixed the issue, the replacement core that they put in there was stronger than the other, and how they put the stronger one in instead of the he the clear

And it's still the best pyraminx in general

No spolier remove it

@@saiyogesh7179 its your issue reading the comments before watching

@@patolol3091 actually it's not his fault. The only thing that puts him at fault is caring

@@klingenschmidt9261 well if you read the comments before watching then you agree do see spoilers so if he gets mad about it its his fault

@@patolol3091 on mobile comments are the first thing you see and it takes over the full screen. It's unavoidable

For sure! There are good reasons to not add it though, bad hardware, hard to scramble, and just variation of current event

@@CubeMasterYT I reckon that with better hardware it would be such a good event.

not really. too similar to squan

@@ButteryCubes it is just like 4*4. If 4*4 has a place then definitely sq1 will also have a place right. All cudes started with worse hardware. Remember a piping sq1 with each turn. We just need to all it and all will happen automatically

@@CubeMasterYT i mean they added 4bld and 5bld, so i dont see the issue. i dont think square 2 is unique enough to be an event tho, maybe a master pyraminx

Yeah I hope

The core of the cube had a defect but it comes with a stronger replacement core.

Don't, the weilong is better

noo the gan pyra sucks

@@bvcghh1684 yeah its infinitely better, especially after doing the steven's mod to it

well, I guess you havent tried dnm LOL

@@fc3x336 I have. XMT 10 is faster and lasts longer than DNM.

@@OlgaFyodorova I can assure youn dnm is faster. it is a water based lube which speeds the cube up INSTANTLY. xmt is a silicone lube which requires break in but doesnt get as fast. xmt lasts longer for sure, but dnm is faster.

@@fc3x336 Have you personally tried both? I have.

@@OlgaFyodorova yea...I have tried both

it's not a pyramid

Hey, a reason I got this cube was because of your comment on Tingman saying it used a good mech, so thanks for indirectly letting me know! I magnetized the slice like a YLM and set it up and it's as lot better and doesn't pop, but unfortunately cornercutting is the exact same as the previous Square-2 (might need more sanding/mods). For me, the screw doesn't unscrew itself anymore, and all I did was replace the spring with a slightly compressed MGC spring and kept it at pretty tight tensions (at loose tensions they always unscrew). Maybe that helps!

The spring was broken btw

agreed

I recommend this tutorial! ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE-IkmlMEHYyzI.html All the algs should work fine, and there are not too many of them!

White top is something that I do, most cubers actually use Yellow/Black top so they don't have that issue. If you want to do white top like me, switch the blue and green cap and the cube's solved state should be white top. For square-1, always have the larger block on the E layer on the right.

Not sure, but I just pressed it a little and unscrewed it a lot and it eventually came off lol, better than being too loose and leaking though

pov you put two comments on a video

I guess the cube really is a lie (my name says it all 💀)

But no magnets or ballbainers

Oh yeah non magnetic just saw lol