It's Finally Done!! | Abarth Engine Swap Ep.9 

If it leaks again I’ll be sure to

We’ll we’re redoing it again because it’s leaking, will adhere to that this time ty!

It was still running, looks like we’re good

@@wellseegarage You know you might have been able to drop the oil pan and just replace the rod bearings without pulling the motor.😁 I'm not saying you can on this engine, but it's possible on some motors. Might not have been a rod bearing and the cylinders probably need some attention anyway, but wouldn't that suck, lol! If you spun a rod bearing then the crank probably needed to come out anyway.

We actually considered it, but like you’re saying all the other peripheral damage/work that couldve been necessary I just decided it would be better to get another motor to keep stock and then build a spare motor for when the time comes.

1200 for 44k miles, automatic 2015 dart rallye

I adjusted the wastegate off camera and tightened it later

Oil pick up was clean, would the torque wrench really be that messed up ?

@@wellseegarage if u set it to a specific lbft and u over tighten it, the internal spring can get messed up and the calibration can be off. Its a no-go to do this with a torquewrench. Oh, and always return the wrench to 0-lbft when not in use.

Guess I’ll buy another one, ty for the useful info as always

it’s the oem OAT spec, but I’ll flush it soon and fill with oem

@@wellseegarage even gm car guys don't run it. It's not good on motor for some reason

Noted

Love you guys, but you should have put an LSD in the transmission.

We will soon, haven’t got the chance to drive it hard enough to need one yet lol