Тёмный

Rebuilding Fiat 500 Abarth CV Axles! 

We'll See Garage
Подписаться 2,1 тыс.
Просмотров 7 тыс.
50% 1

Today I rebuild the cv axles on my fiat 500 Abarth. Using new boots, clamps and grease to replace all the old. This is a common issue with these cars so its important to stay on top of it before any damage gets done.
Be sure to like, comment, subscribe, and check out our Instagram's below !
Awais - / abarth_nyc
Aki - / a4_aki
#abarth #abarth500 #modified

Опубликовано:

 

18 сен 2024

Поделиться:

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист
Посмотреть позже
Комментарии : 37   
@tylerford2651
@tylerford2651 Год назад
Thank you for the in depth review on rebuilding a cv axle no bs just straight into it please make more content
@wellseegarage
@wellseegarage Год назад
Thank you! Will do.
@johncorona4337
@johncorona4337 Год назад
Removing the right side stub axle is not difficult. Three bolts (10 mm) hold the axle in place, pop out with a pry bar. Then assembly goes easier since you have the whole thing out and it's so much easier to tighten the boot clamp when everything is out. Putting back in kinda easy, just keep rotating and pushing until it goes in, secure with those three bolts and you're good. FYI, removing clamps is easier if you pry up the end with a flat blade screwdriver, cutting the clamps is not required.
@johncorona4337
@johncorona4337 Год назад
It's also much easier to make sure the inner boot is on correctly with the stub axle out.
@wellseegarage
@wellseegarage Год назад
I had gotten the bolts removed but the stub would not budge further than an inch that I got in the first ten minutes of me trying with the pry bar all around it, the right sides clunking now so I’ll remove the whole thing with the likes of a vice grip slide hammer.
@BattOnly
@BattOnly Год назад
Learning a lot from you guys! Great work!
@PickledPierogi
@PickledPierogi Год назад
Thank you for sharing! Feel like it’s only a matter of time until I have to do this.
@wellseegarage
@wellseegarage Год назад
Highly recommend pulling the axle out in its entirety when you do.
@adamahmed-hb4tc
@adamahmed-hb4tc Год назад
why is everyone on this channel so good lookin
@XxXDOMINIONXxX
@XxXDOMINIONXxX Год назад
do you have the P/N's for the boots / tripod bearing assembly?
@wellseegarage
@wellseegarage Год назад
I do not, threw out the bags they came in.
@danielmuller7315
@danielmuller7315 Год назад
Where did u purchase the bearings ???
@G_Ozare
@G_Ozare Год назад
Well done boys.
@robertmatthews6655
@robertmatthews6655 Год назад
where did you purchase the boots?? I can't find replacements
@wellseegarage
@wellseegarage Год назад
DI corse
@robertmatthews6655
@robertmatthews6655 Год назад
@@wellseegarage thanks
@gqrob28
@gqrob28 10 месяцев назад
Thanks for the video, with mistakes included! This will help me a lot!
@sbinnala
@sbinnala 8 месяцев назад
Did you find any damage in your axle cups? They’re super expensive and don’t come out easy. My 2017 is starting to vibrate with full throttle in 3rd and 4th. Has to be the tripod bearings I assume.
@wellseegarage
@wellseegarage 8 месяцев назад
Wasn’t anything bad enough for me to recall, usually it’s just the bearing and not the cup that’s damaged. If the boots got too little grease than there’s a possibilty the cup is damaged.
@VQ_menace90
@VQ_menace90 Год назад
cool video, i have the c514, job is gonna be the same though. ughhhhhh!
@mrkrag
@mrkrag Год назад
In the words of a wise old shop dog, "If you would focus, you f*#k..."
@morrge30
@morrge30 Год назад
What year is your Abarth and is it a manual trans? Great video
@wellseegarage
@wellseegarage Год назад
2013 manual, thank you!
@1pfuller
@1pfuller Год назад
Do you have a link(s) to buy the boots, clamps, and grease you used?
@wellseegarage
@wellseegarage Год назад
Dicorse.com, Robert Zecca should have everything you need.
@DisneyMagicwithForti
@DisneyMagicwithForti Год назад
Where you able to get the parts?
@miguelcrespo146
@miguelcrespo146 Год назад
Where did you find the CV boots? I haven't been able to find them.
@wellseegarage
@wellseegarage Год назад
www.dicorse.com/
@danielmuller7315
@danielmuller7315 Год назад
I can’t find anything under dl corse ??? Would you plz put the link in here, thanks
@wellseegarage
@wellseegarage Год назад
www.dicorse.com/shop/fiat-500-abarth-axle-tripod-bearing/
@ronniematthews3408
@ronniematthews3408 Год назад
Where did u buy the boots for abarth from?? Thank you
@wellseegarage
@wellseegarage Год назад
DI corse
@mathewdavis358
@mathewdavis358 Год назад
Where did tou get those boot and part numbers??
@wellseegarage
@wellseegarage Год назад
Di corse
@Coach_Rolando
@Coach_Rolando 3 месяца назад
Hey bud… great video…. Thank you for sharing… I can’t find those damn cv axles anywhere and when you find they are $1k for the set… I’m going to go on your “journey”…. Can you tell me where you found the replacement parts… a link for all parts… I know I’m asking too much but you will help a “handicap mechanic” lol… I have exactly the same car and color lol
@wellseegarage
@wellseegarage 3 месяца назад
I got all the parts from DIcorse.com
@Coach_Rolando
@Coach_Rolando 3 месяца назад
@@wellseegarage greatly appreciated bud
Далее
How To Rebuild & Repair A CV Axle
26:52
Просмотров 66 тыс.
Why I Sold My Abarth 500 After Just 6 Months
16:40
Просмотров 39 тыс.
How to replace CV joint [AUTODOC TUTORIAL]
14:19
Просмотров 124 тыс.
10 Years with My Fiat 500 Abarth: The Ultimate Review
27:54