No video :(

JD L130 Transmission Wont Move Diagnosis

Подписаться 47 тыс.

Просмотров 19 тыс.

50% 1

Turned out it just needed oil it seems. Also replaced the oil plug.
Due to factors beyond the control of Hank's Garage, I cannot guarantee against improper use or unauthorized modifications of this information. Hank's Garage assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. Hank's Garage recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of Hank's Garage, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not Hank's Garage.

Опубликовано:

23 авг 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 15

@butler386 2 года назад

All these transmissions look to be a pain in the keester to change and work on. But you got it done so it has more life. Great job. Thanks for the videos.

@corysgardentractors7084 2 года назад

The pumps in those rear ends are known to let the fluid leak by. Pretty simple system to work on. usually the pump motors get scratches on the faces and cause this issue. usually you can sand the pump faces and get the scratches out and it will work like new. just time consuming to do

@hanksgarage_ 2 года назад

Thanks for the info. Yea I’m on the fence about tearing into it or not. I found a vendor online that sells new ones for $400 though I’m not sure it’s the exact same as this one

@corysgardentractors7084 2 года назад

@@hanksgarage_ IF i am correct that has the tuff torq k46 transmission and the new upgraded model is the k57 and should be a direct bolt up

@hanksgarage_ 2 года назад

@@corysgardentractors7084 yea it’s the k46. Direct bolt up huh? New model any better?

@corysgardentractors7084 2 года назад

@@hanksgarage_ I personally haven't tried one but from what I've been told its a heavier duty transaxle

@BOKEHMASTER 10 месяцев назад

My trans belt had never been changed on mine. I changed it and it Runs strong. However, I think my fluid is low because it still makes that drowning noise at start off

@eighties8 2 года назад

Thanks for sharing the video. What's the process to bleed the fluid? I just drained and topped off the fluid in the reservoir that's accessible through the vent cap. It still makes a groaning noise starting off. I know I probably need to drain and fill the other compartment next but wanted to test this first. I have a X320 JD

@hanksgarage_ 2 года назад

They should self bleed. You are likely low on fluid though this one did that before I filled it made a bunch of noise

@kajlerdog628 Год назад

Do the the k66 upgrade it will make this thing a beast

@hanksgarage_ Год назад

This one? rjrtractor.com/product/k66-upgrade-kit-for-300-series/

@peter55343 2 года назад

Hope all is well. I heard by 2024 California where u live no more new gas small engine sales. Sucks man but glad I don't live in California.

@hanksgarage_ 2 года назад

Yea it is what it is man. It's probably going to boost the used market on machines as well as repairs to keep them running. Who knows how it will go though. Its going to be a lot for them to try and implement. And most of it is very ambiguous and confusing. They are going to have to identify just what it will affect, I can see it being an issue for Gas powered generators especially which new units would apparently be banned. No idea on ATV and dirtbike engines though.

@peter55343 2 года назад

@@hanksgarage_ they are supposed to really target 2 cycle engines especially. But we will see.