JEEP CHEROKEE XJ NEUTRAL SAFETY SWITCH REMOVAL AND INSTALLATION - FREE THE AW4 NSS! 

Np brother! Thanks always for the views!

Thank you !!! Glad you like them!

Thank you so much, good luck on the fix!

Thanks brother! You're channel is doing amazing, God bless 💪

Two of the best ZJ channels in the same comment haha congratulations you both

@@bernardocaldeira4354 thank you! 💪

Hey do you where i can get that quick discount that the lines are connect to by the safety switch????

Will do brother. thank you

@@ProjectDanH excellent and very friendly video. Will this switch cause issues with a jeep 93’ electronic vehicle security remote module ? Sometimes I have to put it in neutral and then i can disengage the security system and it will start . Hope to hear your feedback ❤️

Thank you wilbert!

Thank you bro, glad to help!!!

Glad you enjoyed it

Thanks Mike! You're welcome to copy it 👍

Project Dan H Did you happen to make a video on it?

@@Bulpar nah, but your welcomed to come over and measure it! Lol

Thanks!

Yes! Penetrating oil definitely pays off. Your puller idea was brilliant! Did the NSS. Break?

@@ProjectDanH The puller idea came after I tried other methods that broke the NSS.

Amen!

💪

Hey Byron! Thank you so much for subscribing. If you rescued an XJ for $500 then this RU-vid channel is right up your alley! God bless I'm looking forward to chatting with you in the comments 😁

Thank you so much for the love! Respect to BK. I'm not really sure how the notch customs install. I think a body shop needs to do it because bthere is no mounting hardware. I rather use bushwhacker flats IMHO.

Thanks brother, this is an XJ Aw4 trans. I'm not really a transmission guy so I don't know much about the internals. Thank your for watching 💪

Well the ZJ doesn't have the same NSS as the XJ. But if it failed is wouldn't show a rear lamp failure. At least I don't think it will. Try a new rear lamp module and a new NSS for good measure!

Yes, most likely. The NSS can be cleaned out if you can remove it without braking it. Lol .. use lots of penetrating oil!

Most definitely! Thanks Bug! Congrats on the new house!

awesome to hear! I love XJs, congrats on the 93! Yes, basically the AW4 is out and an AX15 manual is going in. God bless👍

@@ProjectDanH Awesome it is. Hey Dan do you also have a .com or an email address that goes with your channel? Reason I'm asking is once I start checking a vehicle out like I am with this one, I'm almost positive that the 2nd owner pulled the engine & trans out and at least rebuilt the engine. Instead of replying back and forth in the comments, emailing directly would probably be a lot easier. Unless you have other media platforms where PM can be done. Plus you might wanna see pictures so you can see what I'm talking about. Thanks for replying back so fast & God Bless You back Dan. Thanks again, Dan Funny,we're just a couple of Dan's with Jeeps, lol....

@@montydaniels1054 every Dan should own a Jeep 😊. I'm best reached on instagram. @project_danh

@@ProjectDanH I pulled the carpet up on the front passenger side yesterday and the floorpan looked great, no surface rust. I might be able to get a 1999 that is a rust bucket and will need a trans because it's slipping. It has one of those $350-$400 stinger front bumpers (no winch), along with a new set of tires & rims. Guy is asking $950 obo. I'm thinking about buying it just because I'd rather have a beater for the 2 worst winter months. Because this 93 XJ is so clean, now I'm turning into a scardy cat about driving on our salty roads. I've got a set of Hankook Dynapro ATM 245/R75/16's w/Vision Wheel Rims. So if the automatic car wash down the street says that it's go through their conveyor without issues, I might drive it this winter. I suppose I can put the original rims back on but they're studded snow tires and I believe that means I can be ticketed if caught driving with em. I think I'm creating my own dilemmas with this XJ, lol.... Any advice Dan. Thanks, MD...

@@montydaniels1054 if you want the 93 to last garage it in the winter and drive the beater!

Sounds like you may have a vacuum leak. Could very well be an IAC. Make sure you have a good battery and clean your throttle body very well

@@ProjectDanHthanks i'm going to attempt to clean my IAC tommorrow at certain points with ac on when i put it in park with the ac on the rpms get high or low. i have over 300k miles . how do you clean a throttle body if it comes to that ?

You need to know the model transmission you have for the trans output seal and the type of transfer case for the transfer case input as seal

Bingo! Anytime👍

they totally suck! hopefully this video can illuminate the importance of pre-pulling prep! 👍

Yes, absolutely! I should have done that.. but then again its not in a vehicle 🤣🤣

That's pretty cool, they can usually be rebuilt but I end up destroying them during removal because they're so rusted on.

That's the plan! 2001 auto pcm and harness with a 2001 tupy head and coil pack ignition system then a 1999 block with an AX15 manual and a 242 selec track transfer case.. what do you think? plausible???

Sounds like a winner to me Brother....👍👍

@@danhambrick6331 Perfect, Stay Tuned!!!

Excellent tip, will this work for rusted Jeeps?

@@ProjectDanH I have a 96 Cherokee and it wasn't really rusted but it was oily I just sprayed mine with pb blaster and let it sit overnight

just reverse lights.. turn signals should be on a relay in the dash

Hmm interesting I can figure this out then , I have to turn signals and not air or ac in the car since the fuse keeps popping…fuse #20 under the dash

I think so. It connects into the engine harness right by the trans dipstick tube

🤣🤣🤣 why change it now?? stick to what works!!!

What numbers do you jump?

@@jordandevelle4564 ⚠️Bypass at your own risk⚠️ ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE-ed4b70JbcaE.html

sure, come get it!

Project Dan H im in frederick maryland where are you located

@@skippy6069 long island NY

Lol . I love my claw hammer!! I can get 13 ft pounds with these mitts! 💪💪💪

I love your stuff. I'm battling a 99 XJ with no buss no power to PDC fuse 24@@ProjectDanH

IDK.. I never actually thought about selling one.... ever! lol

sorry I don't, but yes it is an AW4

Don't think so.. they'll block the nut from spinning.

absolutely Matty

@@ProjectDanH thanks for the great tips!

Just gotta get your face up in there!

I've never had luck up here in NY with just screwdrivers

ahh man! I hate rust

Ouch buddy.