No video :(

Jet Performance Mass Air Flow Sensor 2019-2023 Chevrolet Silverado Trail Boss

Подписаться 13 тыс.

Просмотров 9 тыс.

50% 1

If you are looking to get the Full Potential out of your Cold Air Intake. Don't overlook this Mass Air Flow Sensor! Everything is Electronic in Trucks these days and your Factory Mass Air Flow Sensor is not tuned for Power. In this video we show you How to replace your Factory mass air flow sensor for this Mass Air Flow Sensor from Jet performance. This MAF Sensor allows your Truck's computer to acknowledge you are getting more Air Flow from your Cold Air Intake. This install is on my 2020 Chevrolet Silverado 1500 LT Trail Boss 5.3L. After installing this Sensor, the biggest thing I noticed was better throttle response from take off. This is a Chevy Silverado Performance Upgrade you don't want to miss out on.
Thanks for Watching! Below is a link to the Jet Performance MAF Sensor
POMOCODE for 25% OFF: ZACHATAK25
Link to MAF Sensor: jetchip.com/sh...
Link to their website: jetchip.com
~Make sure you reset your Truck's ECU by Unplugging negative side of the battery for about 30 minutes.
~ This is a direct replacement of the stock MAF Sensor
~Increased HP, Torque, and MPGs
~Gives a more accurate reading on Higher Air Flow Volume than your stock sensor, especially with an aftermarket Cold Air Intake
__________________________________________________________________________________
My Trail Boss Build List:
~N-Fab Predator Pro Nerf Steps: imp.i128439.ne...
~Gator SRX Roll Up Bed Cover: imp.i128439.ne...
~Borla Atak Crate muffler: imp.i128439.ne...
~Sunpie Rock Lights: www.sunpie.co/...
~Lasfit Rock Lights: lddy.no/1fw4b
~Lasfit Reverse Lights: lddy.no/1g8tz
~Lasfit Tag: lddy.no/1gal6
~Lasfit Turn Signals: lddy.no/1exxk
~Lasfit Rubber Mats: lddy.no/1fm67
~ReadyLift SST 2.0
~Nitto Recon Graplers 285/15/18
~Cold Air Inductions Intake
~Rough Country Bull Bar
~Ronin Bullet Antenna
~Footwell Lighting
~Painted Calipers-DupliColor Kit
~Plasti Dip Badges
~High Heat Painted Exhaust Tips
~BDTrims Letter Inlays
~Front Window Tent
~CarlinKit Wireless Carplay 3.0
~K&N Cabin Air Filter
~Chevy OEM Bed Mat
Other Truck Fitment:
2019 Chevy Silverado 1500
2021 Chevy Silverado 1500
2022 Chevy Silverado 1500
2023 Chevy Silverado 1500
____________________________________________________________________________________
#silverado #trailboss #jetperformance #massairflowsensor #coldairintake #chevytrucks

Опубликовано:

25 авг 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 57

@BridsEye1 11 месяцев назад

Thanks just ordered one!! Have cold air intake, paradox muffler and now this!!

@zachattackcustoms 11 месяцев назад

Let me know how you like it. I felt like I picked up way better throttle response once I installed it.

@trailbosschrispayne5454 5 месяцев назад

Zack you ain’t crazy. Just did a 150 mile loop with the jet performance sensor. Man you can fell how peppy it is. After some learning I got 19.4 mpg with 35s and a level same as yours. 😊

@zachattackcustoms 5 месяцев назад

Awesome! That makes me feel much better knowing someone else feels the same way and I feel much better about my latest review on the products. Thanks for the Update!

@86sthet 10 месяцев назад

I got the same exact set up intake and exhaust. Got a throttle body spacer as well with pulsar lt(which I had to take off cause it causes service ESC issues)

@zachattackcustoms 10 месяцев назад

Nice, how do you like it all? I am about to do a true dual setup with another Atak crate. Just have to find time to drop the truck off at the muffler shop.

@user-dn6np4ec9x 7 месяцев назад

i had the same issue i took the pulsar lt off as well , were you able to find a work around to still use it ??

@joseturcio361 3 месяца назад

@@user-dn6np4ec9x if is a 2023 and above pulsar dont work. if is under 2023 u shouldnt have any ESC issues

@trailbosschrispayne5454 5 месяцев назад

Sweet look fwd to it brother

@Boostlee2023 16 часов назад

I installed the stillen ram air, and AFE track force intake on my 2023, all was well for about a month, then bam check engine light yep.. MAF sensor code I said screw it it’s about to have a 2650 on it and be tuned anyway, well about a week ago the truck cut off at a light and would not cut back on after a few attempts, I got out and unplugged the maf and the truck started up and drove fine.. just some info if this ever happens to anyone else and need a way to get home without a tow. Which if you have a refresh Silverado 22+ it will probably happen with an AFE intake

@zachattackcustoms 16 часов назад

Good info, I haven’t had an CELs with the components I have installed yet.

@PrecisionRifleNetwork 2 месяца назад

good information. Thanks! fyi - has anyone told you that the flag in your logo is incorrect? when a flag is hung vertically, the stars are always on the upper left.

@zachattackcustoms 2 месяца назад

Thanks for watching! No, actually I did not know that it had to hang a certain way, but I will look into changing it. Last thing I want to do is disrespect this country and I will look into changing it. Thanks for the heads up!

@Efrainacon Месяц назад

Have you seen that stillen has a cold air scoop for these trucks.

@zachattackcustoms Месяц назад

I will look into it. Thanks for the recommendation!

@WiZop23 Год назад

You won’t really see a difference unless you get it tuned. I’d like to see that truck with some headers

@zachattackcustoms Год назад

I noticed more of a difference in throttle response with this MAF sensor than I did with just the CAI.

@jerryborre4391 5 месяцев назад

I wonder, do you have to tune Ecu/Tcu? For Aftermarket exhaust and cold air intake?

@zachattackcustoms 5 месяцев назад

I would say to get the full potential probably, but the computer is suppose to pick up on different mods. I feel a difference with my aftermarket throttle body and MAF sensor because they are electronic which communicates with the computer.

@BridsEye1 11 месяцев назад

Hey I just installed mine and my auto stop start doesn’t happen anymore. Is that happening with yours? My lane assist works still it doesn’t make beep sounds now. Have you noticed anything or have any suggestions

@zachattackcustoms 11 месяцев назад

Did you disconnect the battery? My auto stop/start seemed like it stopped for a little while and then started back. I would give it some time. Usually when you install something like this it’s good to drive around for about 50 miles in order for the truck to relearn. I don’t have lane assist but I can’t imagine that doing anything to that.

@zachattackcustoms 11 месяцев назад

Also, if you did unplug the battery, it might have reset the lane assist. The settings should be through the radio. I would check through there and see if it set it to be off. Every time I pull the battery loose, I have to go back in and setup all my changes I make to the truck.

@BridsEye1 11 месяцев назад

@@zachattackcustoms thanks today seems like it all working just needed sometime I seems!! Great stuff

@PeteyPablo408 2 месяца назад

Will this effect California smog emissions?

@zachattackcustoms 2 месяца назад

I am not sure, but the manufacturer should be able to tell you.

@bigjlo02 3 месяца назад

I just install mine to my K&N I take and once I start my truck the check engine light comes on and I did exactly how u did it. Any idea how to get rid of check engine light???

@zachattackcustoms 3 месяца назад

Did you disconnect the battery?

@bigjlo02 3 месяца назад

Yes I did. Disconnected the negative and drain battery with the positive and ground. Then I installed it. Turn my truck on and the check engine light was on. So I disconnected battery again to reset it again and same thing. So I just put the old on back in and the check engine light went off.

@mohammadomar7802 10 месяцев назад

I got a question regarding the warranty , so it will effects GM warranty ? Because I have a 2022 Yukon Denali and I’m facing issues with P106 code and the mods I have a volant air intake and bora touring cat back so I’m planning to upgrade the mass air sensor if it will not affecting my warranty

@zachattackcustoms 10 месяцев назад

Honestly I can’t say either way. It depends on the dealer. Some will try to void your warranty with any little mod. Some will actually try to be helpful. I know if I ever have any serious issues, I’m slapping all the factory parts back on before I take it in. Lol

@sphinx5101 5 месяцев назад

Sorry I keep Asking haha If u have the k&n pipe and drop in filter like u did before and the jet airflow sensor And this new big intake kit and the airflow sensor Do u think they would both feel the same same flow or ?

@zachattackcustoms 5 месяцев назад

I do think you would notice a difference with the MAF sensor. I would try that first.

@213funnyp 6 месяцев назад

Did you get higher rpms? When i begin on the highway my rpms are almost redlining

@zachattackcustoms 6 месяцев назад

Are you flooring it?

@213funnyp 6 месяцев назад

@@zachattackcustoms no im just trying to accelerate to highway speed

@zachattackcustoms 6 месяцев назад

I never experienced that, did you disconnect the battery and then when you hooked it backup did you get a notification to roll down the drivers window and close it? I have found that’s how you know you know that all power was drained. Also did you let it idle for a little while before taking off?

@trailbosschrispayne5454 5 месяцев назад

Hey Zach attack. How’s the mass air flow sensor working? Still all good? Tia

@zachattackcustoms 5 месяцев назад

Yes, I haven’t had any issues with it. I plan to do an update video soon.

@trailbosschrispayne5454 5 месяцев назад

Just bought one for my boss thanks to your recommendation 😊

@zachattackcustoms 5 месяцев назад

I feel like it was a good combo for my CAI. Let me know how you like it and if you notice a difference so I don’t feel crazy. lol

@trailbosschrispayne5454 5 месяцев назад

@@zachattackcustoms American trucks had it on sale. Ordered today and I should have by tomorrow;) thanks Zack. Keep up the killer videos

@trailbosschrispayne5454 Год назад

Any CEL from the install? Interested in this from your video.

@zachattackcustoms Год назад

No lights on the dash, but I unplugged the battery for it to reset. You might get a light if you install it without resetting the ECU.

@trailbosschrispayne5454 Год назад

@@zachattackcustoms how do you re set the ecu? You talking about having the battery disconnected while you swap not out? Tia

@zachattackcustoms Год назад

I disconnect the negative and the positive completely from the battery, then drain the power completely from the positive by taking the trucks connections from the battery and connect them to a ground on the truck with a jumper cable. I show you in the video where I made my connections.

@trailbosschrispayne5454 Год назад

@@zachattackcustoms cool. I’ve watched it a couple times. Seeing if the cel came on after the install. Seeing if this will help my random cel popping on I believe due to my cold air intake and the extra air they get tripping out the factory mass air flow sensor. Tks

@zachattackcustoms Год назад

@@trailbosschrispayne5454 You might just need a reset from the cold air intake install. I would try that first before spending the money on the new MAF sensor. But I do truly feel the new MAF sensor unleashed better performance out of my CAI.

@BuenasVibras909 Год назад

Update?

@zachattackcustoms Год назад

Yea I was planning on riding around for a while and then giving an update video, but so far, no difference in gas mileage that I can tell. Biggest difference is throttle response.

@BuenasVibras909 11 месяцев назад

⁠@@zachattackcustomsjust ordered it little bit late of a reply but how your liking it

@juliansilvagnoli2840 Год назад

Have you noticed a difference in throttle response or MPG ?

@zachattackcustoms Год назад

I would say the biggest thing I noticed was throttle response on takeoff, not as noticeable when I am up to speed. I haven’t had it long enough to really notice MPG gains.

@juliansilvagnoli2840 Год назад

Good to know, I just order mine after watching your video. I have 2015 Chevy 2500HD 6.0 Flex with an intake. Haven’t done the exhaust yet, hoping to get better fuel mpg as of now I’m only getting 11.7 in the city 13 on highway.

@zachattackcustoms Год назад

What I would recommend doing before you swap it out is try cleaning your current MAF Sensor and then disconnect the battery for about 30 min and see if your gas mileage improves, but I do like this aftermarket MAF sensor in combination with an aftermarket CAI!