John Deere 6210R PTO problems!?! | Is it catastrophic or minimal?! 

Brilliant video, so interesting to watch maybe those bearings were the problem. I was surprised that some were Made in Japan, but there you go . Looking forward too your next video. 👍👍

Very interesting video. 👍 Thank goodness you done as much as you did yourself as that will have saved your pocket😉

Thanks for the lesson. Happy New Year.

You saved yourself a lot of money by preventing a major breakdown

This is a normal fit! I have taken apart dozens of these, even new/almost new ones, them bearing always fits loose on the shafts and in the housing. They wil run forever with it

Did the dealer mention anything about the bearing races spinning on the shaft and in the bridge housing? I’ve recently replaced the mfd bearings on a case/mccormick and was very surprised to find the bearing races were a ‘loose’ fit in the housing, when I questioned it I was told it was normal and to install with loctite bearing fit compound.

Overalls on and a big piece of cardboard underneath the backend of the tractor would of saved a lot of dirty clothes/jeans believe me from experience as I’ve been there and done that job before.

Don't think you've put a foot wrong on that job👌caught it in time before them bearings broke up and damaged the cogs 👍take it Milwaukee didn't play ball, probably more chance of a scaffolding gang sponsoring you and supplying different different lengths of pipe. 🤷‍♂️👍😂

rough bearings will make that kind of noise.

Is this available in English?

Any news on the old John Deere 🤔

if you have to change your pto every 2 years i think you are doing something wrong.

This is why Belarus tractors are indestructible and very cheap and easy to maintain

Si puo tradurre in italiano

Prendi un cerino e mettilo dentro il serbatoio

Maybe next time you should buy a better tractor, for example a Massey Ferguson!

I'm usually reluctant to watch videos from across the pond because they always do stuff half donkey backwards and or I have translate the terminology, but I did anyways and my assumptions was right. Not only is this not the run of the mill tractor in redneck rural America at 200+hp, but you say the repair cost was about "$1,400.00 quid" really....................