KT200II - Read and Write Sagem S3000 ECU ( J-Tag & Boot )

UnixCoD Automotive

Подписаться 3,8 тыс.

Просмотров 1,5 тыс.

50% 1

Видео Поделиться Скачать Добавить в

Read and Write Sagem S3000 ecu with KT200II over J-tag and boot mode.

Опубликовано:

3 окт 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 14

@irfankhalifa5647 8 месяцев назад

Thank you for your videos very helpful... Is there more protocols with KT200II than Foxflash?

@UnixCoDElectronics 8 месяцев назад

I`m not able to say because i don`t own a FoxFlash device.

@mishokorlov 8 месяцев назад

Good video thanks👍 Over all would you recommend to buy Kt200II 🤔

@UnixCoDElectronics 8 месяцев назад

Hi, yes overall its a good tool for read / write ecu mods files, its not good to clone edc17 ( due to OTP area cannot be skipped )

@mishokorlov 8 месяцев назад

@@UnixCoDElectronics I guess for edc17 PCM flasher would do good job 🤔

@UnixCoDElectronics 8 месяцев назад

@mishokorlov yes, PCM Flash its an awsome software, most of time i use it for Bosch ECUs

@mreepromer4977 8 месяцев назад

@@UnixCoDElectronicsfor clone edc17 must enter special menu then it can do otp too

@mishokorlov 8 месяцев назад

@@UnixCoDElectronics Did you use 77 module for edc17?

@reirizjose 8 месяцев назад

hi, is it safe to do the checksum with this tool? thanks

@UnixCoDElectronics 8 месяцев назад

Yes, all the time when i let the tool do the checksum was ok, without problems