Рендж ровер 2003 года , мотор бмв. Здравствуйте. На видео получается вы прописали новый второй ключь? Что это за плата с красным приводом? Я у себя ключ в замок зажигания вставляю, ключ до конца проворачивается,приборная панель, всё горит ,но машина не запускается. Пробовал на прямую подавая ток на реле стартера, и стартер мотор крутит как будто в холостую, и ток на катушках зажигания пропадает как стартер крутишь замыкая реле стартера. Стартер не крутишь и ток есть на катушках свечей. Может иммобилайзер в защиту входит и глушит свечи?
Ok it would seem that I’m having that same problem or similar, my thing is that mines after putting a kick box on my battery it would than start in run, but once I run it for a while in than turn it off in restart it’s like the battery is drained. But I’m believing that my battery isn’t drained. My question is this the same solution that you just example….? To fixing my problem. I’ve located that is being I’d fuse #18. It’s not blown or anything. Are you saying that that fuse isn’t getting any power. When I put the key into the ignition it’s like it’s locked in don’t turn. But once again as I mentioned once I put my kick box( battery boaster ) on to give the battery a extra kick to start, in then I put the key in and start the car it turn on over and starts. I don’t think it’s the battery because I fully charges the battery
Get your alternator check.. And your battery check. Autozone does it for free.. Maybe the car has a system that wont open the switch until it reads a good amount of power in the battery. From what your saying. Your car switch unlocks when your battery is fully charged or gets an extra boost.. Am thinking that the battery drains when you have the car on and the alternator is not good therefore not providing any power to the car and that why it shuts off.. This is just a guess. You need to know for sure your battery is fully charge and that the alternator is charging the battery then move to the next steps
For this case i worked on the fuse was not getting power. I had the electric diagram when i did this . I dont have it any more.. What i would do 1>Take battery out and take it to your local Autozone to get it tested and if its good leave it there to get it fully charged then go pick it up. 2> Install the battery and Attempt to turn the car 0N for the first time with battery fully charged.. if it turned on. Take it to your closest Autozone to get the alternator tested, dont shut off the car. Battery food? Alternator good? Go home, let it seat until it turns off like it was doing. CALCULATE THE SAME TIME IT TAKES TO TURN OFF by it self. If the car turned off by itself while running. Attempt to turn it back on, check if the switch gets locked in your 2nd or 3rd attempt of trying to turn it back on. __________________________________ If the alternator is good and battery is good for sure not guessing. Check if your switch locks after the second time of trying to turn it back on . Then you can try this option here in my video.. -----------------------------‐---------------- Easiest way to open the swith without running this cable its using a POWER PROBE to send a 12v charge directly to the top insert from fuse 18 u mention or the one i was working on the video. Note that it might need a couple of seconds to open the switch so constant power needs to be sent through the fuse for the switch lock to unlock. [Note that the video i made the battery and alternator where fully charged and working properly. We knew that alternator was charging the battery and battery was good] If your car switch opens every time you turn the key with the battery fully charge without the kick start. Then am guessing your switch is good and you might have something else going. IF YOUR CAR IS DRAINING THE BATTERY TO NO POWER AT ALL. IT AUTOMATICALLY RESETS THE SWITCH AND WHEN YOU PUT THE KICK START> IT PROVIDES POWER AGAIN AND THE SWITCH TURNS ON THE FIRST TIME.. IF IT DOES. SHUT IT BACK OFF AND ATTEMPT TO TURN IT BACK ON. IF THE SWITCH IS LOCK, BATTERY FULL AND ALTERNATOR GOOD. THEN YOU CAN TRY THIS VIDEO. GOOD LUCK
Very interesting but unfortunately no translation... Try looking at what I do in the video and just copy. Look for the cable I show to get 12v from the light. Connect that cable to the fuse i show in the box and thats it. Is that easy. What i am doing here is using a cable to connect the brown cable where 12v power feeds the light to the fuse i show on the fuse box. This will cause the switch to reset and you will be able to open the switch everytime. Très intéressant, mais malheureusement pas de traduction... Regardez ce que je fais dans la vidéo et copiez-le. Recherchez le câble que je montre pour obtenir 12v de la lumière.. Connectez ce câble au fusible i montrer dans la boîte et thats it.. Est-ce facile.. Ce que je fais ici est d’utiliser un câble pour connecter le câble brun où l’alimentation 12v alimente la lumière au fusible i montrer sur la boîte à fusibles.. Le commutateur se réinitialisera et vous pourrez l’ouvrir à tout moment.
