LIVE BAIT TANK Install, start to finish, Stacer Proline. 

First 2minutes. That’s a bloke who does things right. You can tell by the ease you have with your tools alone. Great vid mate cheers

Like the sound of surprise in your voice when it all worked. Good job.

I have been told in the past that all negative wires should be connected to the negative battery terminal and not to earthed to the alloy hull. I was told this can cause electrolysis to the alloy.

Great work mate

Fantastic!

Great video mate

Awesome will definitely be doing this on my next boat

Sensational Wayne. great job. If you can do it yourself to save money why not, well done mate.

Great job.

Bloody legend mate been watching your vids for awhile and learnt alot.. thank you 👍

Bloody good pump mate

Hi Wayne I put a stainless pickup tube Years back on my tank was handy without worrying about bubbler.. but yours looks great

Good vid mate, I’ll be making a tank soon, I like your sliding track idea, I think I will do something similar.

thanks for watching

🤯

Just to tidy up all your wireing and a bit of protection from sun look for a product called split loom it’s a hard warring ribbed plastic that you just slide over the wireing simple cable tie hold it in place very neat tidy most places carry it like super cheap Bunnings. Jcar. It’s how most boat shops keep their wireing neat

I don't think you need a pump to pump out, mine just has a overflow tube and it runs out, saves power running a second pump

Does the wife like the everything bit?

Awesome video mate. Had any dramas with the aerator clogging up? I have the same one and it blocks so fast and stops pumping

Good one, is there any reason you haven’t fused the pumps?

Hey Wayne did mounting it there affect the transducer in anyway?

Hey mate just wonder what size pumps you used thank you turned out great

Do you use fishbrain?

Where did you order that livewell tank from?

Mate just found this vid so my comment is a bit late. Not wishing to rain on your parade, however each circuit needs to be fused or protected with a manual reset circuit breaker, not straight off a battery terminal. Your negative bus also needs to be well insulated not in the open where it could track or short to the hull of the boat and become corroded. If one of those single insulated cables rubs through and comes into contact with the hull, a short circuit may occur. Without a protection device in the circuit, high current will flow until the cable burns through or worse. The fuse size needs to be rated for the current carrying capacity of the cable so the cable cannot become over loaded. Your battery box may have one large fuse or CB however may not open circuit on a smaller cable fault. You should also have a main isolating switch to disconnect the battery from all out going circuits, as close to the battery as possible. I've seen aluminium boats burn on their trailers when cables have rubbed through due to not being able to isolate the battery, or the owner has forgotten to turn the isolator off. It's spectacular, especially when the fuel vapours from the tank breather ignite.

Nice build mate. Ha ha ha... I can't get past the really white hair... Have only ever seen you with a totally shaved head or wearing a hat... 😜