Maintenance guy's full EDC work setup! 

Same here. I work on scuba equipment and that one wrench has come in so handy.

No it has to be a paper straw

No Chick-fil-A straw is a must, not optional.

Good idea- that would almost make the adjustable wrench obsolete if something like that would work on the little channel locks. I'll give it a shot sometime soon and if it works out I'll upload a short shouting you out.

No worries sorry I should've been more clear. I had to modify the lanyard a bit to suit my needs. First, I cut off the little ring and did away with the flimsy smaller cord. Then, I placed the big loop around the screwdriver. It doesn't fit exactly snug, so you need to take the slack from the big loop and insert it into the smaller sized loop. Then, to prevent it all from slipping out I put a tiny key ring into the new loop that was made when I inserted the big loop's slack into the smaller loop. I'm sure there's a better solution, but I've never had an issue with it getting in the way or slipping off. Hope this helps!

Ah, thanks, I bought the screwdriver and love it. Works fantastic for installing ceiling fans. With the light and all, installing the blades takes a 3rd of the time.

I updated the description so you should see the little lanyard there at the bottom. I just cut the little ring and rope part off and replaced it with a tiny key chain. So far its holding up well and only $8 for 5

The link to the carabiner is not correct. @@wookiescookies

It may be a little pricey for what it is, but it's small enough that it sits in my back pocket comfortably even while sitting. It's also helping cure my pepsi addiction ;) . Hope you end up liking it as much as I do!

Theres a link to it under "Amazon Lanyard" in the description