Micro Pavé - 1,3mm blue and white diamonds - vandoorendiamonds 

Thanks Ollie, obviously there are many ways on how to set diamonds in a circle but this is my personal preference.

jaime eduardo sequeda becerra thanks for those kind words

Thanks for your comment Cecil =)

Good morning and thank you ! =)

Thanks Ruud, sometimes I also split and sometimes I cut it in half. Depends on the width of the prong ;-)

Wakita Sioux Thanks for your comment. All blue diamonds are natural and therefore each and very single one had a different sparkle. Kind regards !

English please ?

@@heinikendude jeweller👍👍👍👏!

Thank you Robert

Hi Anthony Moses, no I measure all my diamonds to be the exact same size. If you work with 2mm diamonds I measure them to be 2.00mm and not bigger or smaller. =) Otherwise this would mess up the alignment Regards

Hi Hyun Jun Jang, That's a tapered bur. No all hand sharpened gravers unto 60 degrees. Regards, Niels

India

Thanks once again!

Wow, late reply. I start working from the center outwards. One stone in the middle, six of equal size around, 12 of equal size in the next circle and so on

This tool is just a prong pusher (but then a bit bigger) so you can actually use the adhesion force of water to pick up a diamond by it's table.

Hi Peppe, determine the middle of the circle, measure the diameter of your diamond and start from there. The magic division is always 1 - 6 - 12 - 18 - 24 but you need the same size stones for that to be possible. As you can see with the first 7 : 1 - 6. The other rails are just continuing

It is PI, right? 3.141. So PI equal sized stones fit around 1/2 of the original. 2 x PI equal sized stones can fit around 1 stone, that makes 6 stones fitting around the first stone and you add another 6 stones for each increasing ring? So the magic division is always 1 - 6 - 12 - 18 - 24 - 30 - 36 - 42?

Not yet Jaques, but will be online in the future =)

Thank you Yuri!

That's a graver. We use to create bright cuts ;-)

Thanks!

Please tell me 🙏

Hi Biman Das, No we are a family business. Unfortunately no vacancies

If there is work elsewhere, please tell me

Please 🙏🙏

Start your own business