Milling on the Norwood HD 38 

Thanks for the encouragement!

Thanks, appreciate the encouragement. We finally did purchase a cordless mike that I have been using in the more current videos. It does work a lot better. I am sure there are even better one than the one I am using now. A lot of details in making a video. Thanks again David!

It is counter-intuitive, but after watching numerous videos and speaking with Norwood the log loader should be on the non-operator side - I think the log stops are on the wrong side - but not the way Norwood set up the bunks and where they put the pre-drilled holes. Thanks for the comments.

​@@OzarkSawmillServices I am IN NO WAY an expert, but you are the first I've seen who cuts from the front towards the rear of the trailer. If the sawhead would be turned 180° and the logloaders moved to where you walk now it would take away the "roll the logs over the stops"? Anywho, the important thing is that it works and produces lumber 😉😋!

@@johanneslaxell6641 I hear ya! The problem is with the design of the mill and their instructions. I can not turn the saw head around because of the hydraulic system. There is a way, but I would have to disassemble the whole thing and turn the log bunks around from the way their instruction said to put it together, and then put it all back together again; but I ain't willing to do that at this point. I did an earlier video explaining this but don't know which one it was. It is a little frustrating to have to do it this way, but what do you do... They claimed their engineers couldn't come together in the same room during Covid when they put the Instruction Manuel together. So, thus where we are at. Thanks for the observation.

@@OzarkSawmillServices Sorry to hear that. Sometimes wish that an old saying used over here would not be true. Translated: What you win on the swings you loose on the crousel...

I like you pushing the saw head instead of a power feed as you feel the saw cutting and if it is lagging change the blade or you are cutting through a knot.

about $30k for the setup we have.

that was pine for some stickers - i'm not sure what you were asking.