Moen 5-Series Bidet EB2000 | Installation | Review 

I'm glad that it's helpful for you :)

Glad it was helpful :)

For tankless this Morn one has all the essential features and decent price. The BioBidet Horizon/Discovery has the exact same design but added UV sanitization and automatic lid open/close. If you don’t care about these 2 features, then the Moen one would be better for you.

I don’t think so. This is designed to flush out the old water in the system first so it only use new fresh water to wash.

Cool just thought maybe there's an option. Thank youi

Yes there’s a button on the side towards the back (on the opposite side from the water hose). You can push it to unlock and remove the seat

Yes that's normal. It turns blue when UV sterilization is in progress. Once it's done and ready, it will turn back to red.

Yes I just hand tight. You can also wrench it tighter if needed.

That’s a bit too advance for me. If the nozzle is broken I would recommend getting warranty replacement.

You may place a layer of pumper’s tape over the threads to make it water tight. If that doesn’t work, then may get a metal t valve from Home Depot or Lowe’s

Yes, it dose a pre-wash to clear out old water in the system when the sensor is activated.

Try holding both buttons till you hear a double beep. Check out the owner manual page 16 assets.moen.com/shared/docs/instruction-sheets/ins11010c.pdf

I'm having the same problem... cannot turn the beep off! Any other ideas?

Yes. At the remove the third round button at the bottom, it says “seat temp”. Press it a few times till the indicator light turns off.

Mine was 18.5 inch from the fasten hole to the front edge of the toilet bowl.

There’s a release bottom at the left side towards the back. Push it then you can slide the seat back out.

When you first sit on it, there would be a system flush to remove the residual water in the system. When you use actual wash, it should be warm/hot water according to how you set the temperature.

This one had no auto open/close. The Biobidet horizon has auto open/close. The design and installation is about the same. ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE-P6hGz1cGscI.html

When you first sit on it, the system will flush out the residual water inside first, then then rest of the water will be heated up. There's no way to change the initial flush. But if your problem is feeling the jet water cold at first, you may try to turn up the temperature level so the water heats up faster.

Yah, I use a towel to block the water on the other side then clean it up later 😝

Thanks for the comment :)

I actually like the music 🙂

Yah it's a newer home so have prewired electric outlet. Otherwise will need to get a extension cord from the nearest outlet.