My Toolpost Fixture Alignment Locking Screw Upgrade. 

SEE LINK BELOW:- Machifit AXA Size DMC-250-111 Wedge Type Tool Post -- bit.ly/2lO5Kll Quick Change Turning Facing Holder 250-101 -- bit.ly/2HmNqsO Quick Change Turning Facing Boring Holder 250-102 -- bit.ly/2Hwh5iw

Nicely done! A compound replacement block is high in my to do / wish list. I might just have to copy this design. Thanks for sharing. As always you inspire me to get my butt in my shop! -Joe

Nice one Steve. Another great lathe upgrade. Good to see you back on RU-vid making projects. Thanks for sharing. Cheers, Craig

Nice tool post vise, can you post a link to where you bought it? Thanks.

I wish you would have indexed it one last time to see if it hit the first hole. Must have been a good sharp bit!

I am glad to see you again Steve, & nice tip...

Very nice strong and accurate setup. Great ideas. Thank you for sharing.

Once again Steve thanks for great videos and brilliant ideas.

Great Steve, hope your doing well and your family with all that happening.

Lovely!!! Nice and elegant modification!

There sure is a lot of flex of that part when the drill is being pushed inward. I this just from the part stick out or the chuck/spindle not tight?

I like the discs, but wouldn't a bar work just as well? I'd think it would give better support than just two-point contact.

thats a good upgrade.. good call

Great video 👌🏻. Where did you get/design the drill tool holder?

Very nice!

Gday Steve, certainly a rigid set up, perfect centre height as well, can you tell me what type of oil you use, at a guess is it chainsaw bar oil?, when you put it on the end of the drill bit there was no “flinging” off when you spun it up which there’s less mess and no wastage, thanks for another great video mate, cheers Matty

Steve, just sharing my experience trying to order a Machifit 250_300 quick change toolpost and 8 tool holders(250_301) Banggood have all the items listed as in stock and order processed in 2 working days. The 8 tool holders are estimated for UK delivery in about 20 working days(not too bad). The toolpost,on the other hand, is estimated to take 50 working days for UK delivery(too long). This order would have totalled over £450.00 gbp. At that sort of amount I would expect all the bits to arrive at the same time and certainly quicker than 50 working days. Needless to say I didn't complete the purchase.😥

great job as usual steve. very nice upgrade and looks like it would work flawlessly. keep up the great videos as all of your work in your shop is very inspireing. thanks again steve.

Nicely modded,Steve. That set up is sure to give reliable alignment. I experience the same tool post alignment 'creep' as I tighten the pillar top nut when I'm trying to align a parting or threading tool parallel to the chuck face. It often takes a couple of re-adjustments to compensate for the nut dragging it out of square.

So simple, yet very effective

Hi Steve,. that is just brilliant. I have noticed how the toolpost does move sometimes even with tightening up solid. I haven't been able to make that solid block yet to hold the toolpost holder but when I do it will certainly have this addition to it. I've had other commitments to deal with and one being to overhaul my shop completely so bin limited on lathe time. Thanks so much for showing this. Your fan, Dale in Canada

Been following for a quite while.. always love the projects. How you locking Chuck ?

how did you get that perfect fit?