Are there color matched screw plugs for the caribbean blue deck boards? An, no routed the entire length of the board. That's something I didn't know. I wish the caribbean blue was available on Columbus profile, but I will have to route for the fastenters since I don't want visible screws. Don't think I could get that L-shaped groove carved in to the Cortes board Unless I could fit a dremel blade in somehow. Would be a pain, but I could possibly do it, but then would need to get some sealant inside where I cut. I want to make a small landing outside an exterior door but need to figure out the measurements and how many boards I would need. Again, I wish fascia board was available in the caribbean blue. Is it just an unpopular color? I suppose worst case I can use primed PVC boards and then paint them for some of the edges and for riser covers on the stairs. For people who aren't using boards on the sides, it would be nice to get some sort of end caps for the Magellan and Columbus boards. Although, I suppose it would look nicer to use boards on the edge and miter them to hide the edges, but not everyone will want to do that. Shoutout to Richard Lam for answering my e-mails and giving me some info on the router bit size (1/4") and letting me know that some of the boards are not available in the caribbean blue.
We have a concrete porch 8 by 10 No railing yet What can we do about it ? We cannot just lay this type of flooring on top of the concrete without securing it?
Love NewTech. All of it is great for quality, look, durability, installation, etc. However -- No end caps for starter boards. So all my boards have end caps except for the first and last boards on the deck. ????
