Nitro Burnouts and Racing with a GY6 150cc Maddog Nitrous Scooter 

💯

Bruh where can I buy a wiring kit .the control side for a maddog 50. Parts for scooters are out till July. Desperate.

@seanmayo206 no idea. EBay or Amazon is the go to. Or buy some wires at tractor supply and make your own.

It's running strong.

Watch my how install it video. You can do it safe if you don't get greedy. Mine is s 171cc

Was it going 45 on the bike speedo or GPS? Why I ask is 30 GPS is about 45 on speedo. If they were both GPS speed and the bike has slowed down that much I would look at the belt for wear and size. Many times people replace the belt with too short of a belt as a Google search will make you believe. The belt should be 788x18. Also if the belt is too thin from normal wear it will slow down. It should be 18mm wide.

No maddog has a centered wheel. LOL. They are all off center in the back a little. I was thinking they were too far right to clear the shock. But the front one will be centered so the disc is centered in the caliper and then the wheel falls where it falls between the forks. If you want to center it in the forks you will need to space out the caliper also. Or you also sand material off the threaded caliper mount to move it the other way.

@@GhettoWrench do you recommend using loctite on any bolts on these things? They sure vibrate a ton lol

@headwaystudio the only "important " thing that rattles loose is your exhaust header nuts. Check those often. 10mm. If it starts sounding like a bubble machine they have fallen off. After about 3 tightening they seem to stay. I don't like locktite in anything going into aluminum. I just check the bolts alot. The Kickstart bolt loosens also. It should not be wobly on the shaft.

@@GhettoWrench Sounds good. Do you know the torque specs on the wheels lug nuts/axle nut? Cant find any info anywhere

@headwaystudio Just search GY6 torque specs and they are all over. That axle nut is tight as you can get it! I have only seen Gen 1 axle nuts loosen though.