I have the app set to reprogramming mode, and the rlink2 multimedia turned off and now it is black, how can i reset the application to default settings and turn it back on?
Hi Brother, My vehicle is Megane 4 1.5 dci 2016 Model Sedan. "Check Auto High Beam" signal appeared on my vehicle. With the ELM 327 Wi-fi device, I read and deleted the DTC fault codes with the car scanner application while the vehicle's engine was running, but these 3 DTC fault codes were not deleted; Dashboard/Instrument Cluster (11 bit) U0182(87) Data bus lamps control module, front - no communication, BCM (11 bit) B15D8(87) and B1568(04) and "Check Auto High Beam" signal still appear on the screen. Do I need to clear the DTC signals with the ignition on and the engine off? What do you think is the fault) Is the UCH faulty? Does the UCH need to be reprogrammed? When it gets dark, the automatic dipped beams are activated, but the light sensor seems to be intact, but the automatic high-to-dipped beam function no longer works. This signal appeared when the vehicle's 12 V battery was close to exhaustion, I measured the battery and read 12.20 Volts with the engine off. I bought a new battery and changed it. But the signal was not deleted. 3 years ago, the car's radio sound was close to dead, and the windows could not be opened and closed, then when the battery was changed, these problems were normal, but now they still continue. The high beams work, the low beams work, they are solid, but there is no transition from high to low to high. It is outputting a fault signal. I'll be glad, if you help me. Take care
When there are immobilizer problems during a key coding process, the vehicle sometimes starts and sometimes doesn't, should I just try to reprogram the keys again or should I reflash the module?
HI...I have bought Renolink and a new keycard for my Clio 4. Now the old key does not work at all and I don't have the ISK amd Pin. Is there a way to get them? Please help. Your assistance is much appreciated.
how did you get a connection to the probe? I get rid of the red x but then I get this message Character spacing is invalid and cannot be removed. I just want to read the pin of the cards and then establish the connection for learning and programming and then after that has happened successfully cut the connection.
Hello, i have RenoLink 1.99. my interface is connected but when i try to scan, the scan menu goes up to 50%, then it says "Finished scanning" but nothing appears. I don't understand what is the problem... Thanks for your video, do you have any idea about my problem ? Thanks a lot.
Hy from what I understand this interface can work on different models brands if you install the dedicate software ? Any way so from description if I want to acces abs and different modules on a renault I need the obdlink ex? I have a problem whit an abs module renault espace 4 and I want to check the sensors wheels. Tha k you
Hello, I don't recommend you to buy this software if you just want to diagnose. It is very good but if you have it in the original version, so if you have the clone version you will have surprises. Regarding what you asked why one can read and another can't, the logical answer is that the MCU is different and the functions of the Hardware are reduced.
@@YOYODiagnostic Hello, can you please tell me where I can find this and how to do it? Or is it the same step in the Espace as in your video? LG. Kalle
@@YOYODiagnostic no error code. Car was fine and it comes to the shop for a spare key. I program a new key and everything went smoothly but car didn't start. Remote working (it's a Renault duster 2020)
Bonjour Question pour savoir si renolink tu a eux déjà marque Trying to connect... Error: Le remplissage n'est pas valide et ne peut pas être supprimé. Diagnostic stopped besoin d aide Merci d'avance