Driving/ compressing a P38 radius arm bush through a taper bearing race. This is vehicle specific as the P38 radius arm bushes are compressed as they are driven in. Sorry for the sound, and sorry it's not a real radius arm - works just the same though
I've used:
i. a 58mm OD bearing pusher (ebay kit)
ii. an M40 Washer, OD 58mm
iii. Jubilee clip 50-70mm x 2
put one jubilee clip over the pusher and the washer, put the other over the top end of the radius arm bush to stop it spreading under load (you can add another mid way down the bush if you want, but as you drive the bush then you'll need to stop and remove it)
Then drive the assembly through a 30306 taper bearing race
28 май 2019