Passenger side Blend door actuator 2003 Yukon XL

Подписаться 27

Просмотров 16 тыс.

50% 1

Changing the blend door actuator passenger side for 2003 Yukon XL. Changed do to hot air blowing out passenger side only. I was able to get both screws back in and fastened. Get a pry bar. Tedious wrenching and much patience will get it done.

Опубликовано:

8 мар 2022

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 13

@rlwright110 2 года назад

Thanks

@adamshamsuddin 5 месяцев назад

Fastest way to get this done without cutting the vent with a saws-all is to go ahead and remove the dash (not that bad a job - lots of videos out there), and then loosen the bolts holding the air vent in place. Take a long pry bar through the air bag hole and use the metal bracket for leverage to lift up the vent and you'll have plenty of clearance to do the work.

@steveloux4709 2 месяца назад

Did you put the other screw in that is closer to the driver side?

@calebdurfeecpe 11 месяцев назад

Are the passenger and driver's actuators identical? Or are they location specific?

@adamshamsuddin 5 месяцев назад

Identical

@dh5254 7 месяцев назад

In case anyone is thinking about it buy a pass through ratchet first

@mpc77769 21 день назад

@dh5254 now you're talkin'! I'm FINALLY gonna get to this crap this week and you just made the job little easier 👍

@edwardmikidadi5912 Год назад

How did you calibrate it

@adamshamsuddin 5 месяцев назад

If you removed the neg cable from the battery, it will happen automatically when you start her up. Just don't touch the controls.

@DeeBanga Год назад

Part # you used

@killanige 2 года назад

Too bad you didn't show how to get the air bag and all the vents out

@curtisclevenger8800 Год назад

He literally did

@steveloux4709 2 месяца назад

there are other videos out there that go into more detail on how to do that - for the same reason. But this guy's hack on the ratchet probably makes all the difference.