Peugeot SpeedFight 2 Maintenance 

Thanks for Posting this Jacob. Nice video of some basic maintenance. Don't apologise for 'Bad English' m8, it means you speak more languages than most 👍🏻

Thanks for a great video!

Top video! Bedankt

Awesome!

Dat is een mooie speedfight! Ik rijd zelf een NRG power, maar eens speedfight blijft hoog op mn lijstje staan.

Thanks

Good video 😀 fancy coming to service my Peugeot moped? 2003 model with 500 miles. Former race team paddock bike 🏍

Hello, I have a problem, I have a Peugeot Speedfight 1 100cc that recently seized up/heat seized. It was not tuned. I then changed the cylinder, piston etc. It now starts up right away, but after a while it dies all of a sudden (as if you had turned off the key) and then I can start it right up again, this usually happens when I go over 60 km/h or uphill. When I changed the cylinder etc, I also cleaned everything thoroughly, such as the carburettor, intake, new air filter, new fuel filter (there was no fuel filter before) new spark plug. I also removed the oil pump and put a metalplate with a gasket over the hole instead, I now mix the oil directly into the gasoline. Some other info that might be important. - When I drive over 60 km/h, it starts to make a noise from the variator (CVT), it´s sounds quite a lot. - When it died, I tried to start it again while it was rolling and then it started right away, but it made a noise from the variator, like something "let go" that had been seized up, like a rubber sound, maybe from the belt. - The variator belt touches the variator cover on the inside and has grinded a cut in the metal. - In the variator, where the weights are, the belt does not go down to the bottom of the wheel. - The clutch bell had turned blue from the heat. - The place where the connecting rod attaches to the crankshaft had turned blue from heat. - There was no fuel filter on it before. But i now saw there is an internal fuel filter in the gastank, can it affect the vacuum if you now have 2 fuel filters. Please help me. Regards Andree.

what the names of the tool you used to open the air filter books and caburator?

What belt model and length for peugeot speedfight 2 I have. Seemingly original but too loose

Hi what rollers did tou find best?

Hello can you show ma where are you mount side stand for SF2? Thanks

Hello. And what is the carburetor and cylinder volume?

Hoe weet je nou dat je v-snaar aan vervanging toe is. Bij grote beurten wordt ie ongeveer standaard vervangen maar is dat wel nodig... die snaar van jou ziet er gewoon op het eerste gezicht gewoon goed uit...dus...kan je dat toelichten? Die laatste schijf van de variateur heeft allemaal tandjes...moet daar niet wat vet op?

Jacob, ging de scooter 80km/h met de varioplaat nog erin? Ik heb een Speedfight 2 AC gekocht en zou de scooter gewoon wat harder willen laten optrekken maar niet zozeer veel harder laten rijden. Wat doe je dan best? Thx

Hallo Jacob, Ik heb sinds vandaag dezelfde uitlaat als die jij hebt voor mijn speedfight 2. Ze zijn behoorlijk zeldzaam geworden die originele pijpies , volgens mij..Ik zie dat die doodlopende buis bij jou er ook nog op zit, als ik die buis een stuk inkort en een dop erop las, zal dat dan veel schelen in de top/ trekkracht denk jij? Of zal ik het maar gewoon zo laten. Zelf heb ik ook een Polini Vario erop zitten en een witte Polini drukveer 7 %. Hij rijdt nu max 65 maar wil er nog een paar extra km's bij scoren. Toffe video's heb je trouwens.👍👍. Mvg Joey

Hey Jacob, vraagje. Die achterveer... Is die van Betor? Was je daar tevreden van? Heb je die vooraan ook vervangen met één van Betor?

hello i bought a speedfight 2 with couple of defects . first defect is dead baterie. second is rear brakes are not working (there is the wire but they do not touch with a wheel). and i have a question, where is place to input your key to open your seat?

hello, i was looking at your carb and i have the same one. What air mixture screw is that, i don’t think i have the tool and i was wondering what the screw was and the tool needed to tune it.

Hi!can you say where is speed limiter?

what is the best exhaust that you can get for speedfight2 ?

hoe heet het gereedschap dat je op 2:14 gebruikt? die van mij is kapot en ik heb er nooit de naam van geweten.

Hey, op welke plek zit de bougie?

Why you run the motor with no oil line connected?

Hello I bought the same bike 1 year ago and still didnt touch it at all. If someone could tell me what to do please I have no idea about mechanics and the bike is dying slowly :( I have no garage and no tools, what should I buy?

Belt cm? Baga Gr?

Hahah jij bent sws nederlands ik hoor het gewoon.

you can help me my speedfight 2 100cc bike loses power when accelerating and does not revolutionize. it's very difficult to get parts in Mexico you can help me

Jammer ven het filmen met tegenlicht, slecht te zien zo.

I have seen some videos,but yours is the best! Slowly,not In rush,using the tools you should use,good video quality.Do you still have the scooter/moped?I am rebuilding one that was trashed really bad, bought new parts,apart from the main frame and some plastic pieces:))