ESPECTACULAR LA MAGIA DE ESTAS MAQUINAS TE CONTAGIADO Y HACES UN BUEN TRABAJO...FELICITACIONES...! ! ! DESDE ANTOFAGASTA-CHILE...LA CAPITAL MINERA DEL MUNDO...LA CONTAMINACION Y EL CANCER...! ! !
I have a CLD-D99 player,There is black interference when playing the inner track of LD,but it is normal when it plays the outer track. CD playback is good. It is not caused by tilt because no crosstalk appears.I replaced pick-up and mechanism system,the black interference still appears...
Innertrack of ld spins at higher rpm, spindlemotor draws more current. LDs spins at about 1800rpm when read near the center. CDs spin at about 500 rpm when read near the center. So I would suspect a power supply issue, based on information availible in your comment.
@@jacky_L233 H0 = Spindle overcurrent detection error In the play state, overcurrent was detected in the spindle motor. Monitoring starts 5 seconds after the start of play or special playback mode, this error is detected if the overcurrent port is "L" for 4 seconds. Probable cause(s): Motor KO Clamper rubbing H1 = Partial short error At LD start-up, the speed did not reach 1,200rpm without a certain time (12 seconds) after the spindle run command At CD start-up, a certain speed (313rpm) was not reached within 6 seconds from the end of spindle acceleration. Probable cause(s): Spindle motor KO Commutator KO Bearing too tight Power supply KO
@@Magnus.Skovrand My CLD D99,I replaced the power supply,the interference gets better but still exist.However today my player spins disc at counter clockwise just like m.ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE-S3WRTskqObk.html#searching .How can I deal with it. I suspect the spindle servo issue.