Plumbing in flats - Chrome pipework 

Great job , well done 👍

What a real ballache that job looked. You did your best and it looks smart!

Nice neat job as always Luke, good to see Bailey too 👍

Great job 👌👌your work is always top notch

That's a good trick swaging the end of the chrome pipe so you can solder it. I'm stealing that thank you 👍

Great work 👏

Brilliant work mate

Love your videos mate

Chrome to copper lookin proper 😍😍👍🏿👍🏿👍🏿😘😘

Top quality work pal

Baileys one hell of a bender

Tidy work. Challenging job - Wastes look interesting and shower pipework into a 4" wall with soft bricks and lime mortar ! McAlpine do a really neat solvent plastic pipe to compression chrome MCALPINE ABS32/35A-CB. Much neater and smaller so no need to struggle concealing the large nut. Only discovered myself a few months ago. This is not a criticism but a discussion point only... The building regs changed 18 months ago where heating pipework not within a room should be lagged ie - in a floor void (even if not a cold area). My immediate thought was how can this be achieved - one can't notch 70mm out of a joist to accommodate lagging ! So I appreciate the method you have adopted here and would do the same myself with the heating pipework. Has there been a relaxation/reversal on this change as it is close to impossible to implement or is it just brushed under the carpet ? Is this something you are aware of. Thank you ps it is nice to see lagging between the pipe and the joist.. do not see that very often.

Hi mate where the compression nuts come out the wall for the basin etc will they be visible? Also did you fill the chases in completely for the bath shower mixer with foam? Ive filled with foam a few times which is quite easy but when its quite wide not sure the plasterers are keen, i thought they would just bond it then skim over the top no probs

What do you use for your shower fixing the 3/4 threaded pipe stuff?

I'd be rather reluctant to cut the notches out that deep in them joists for that island waste.